Let Us Help You Repair it Yourself!
111/112 Coupe, Used Parts
1968 to 1983 4 5 and 6 Cylinder Gas and Diesel Engine Fan Clutch ( Used )
Good Used BEHR German fan clutch replacement for 113,111, 108 and 109 chassis gas engines from 1968 to 1973, all 114 and 115 gas and diesel, all 123 gas and diesel engines 1977 to 1983 and 1981 to 1983 126 300SD. PLEASE NOTE: This clutch is for engines that have the 5 blade aluminum metal fans. If you have the newer multi-blade nylon fan then you will need a different type. This clutch lists new for $272.00. If your fan clutch is loose, making noise, or your engine is overheating this is your chance to replace it for a very good price. We also carry these new for $178.00
I have aluminum fan blades used if you need that also. Email for price.
PLEASE NOTE: This will not fit 107, 116, or 126 V8 gas engines.
- 189 reads
Late 111 108 109 113 Black Steering Wheel and Horn Pad ( Used )
This steering wheel is not perfect but it is above average. No major damage on the rim but there are a few very fine cracks right where the center bar meets the outer ring. Very good horn ring and horn pad (no cracks in the pad cover).
Has 5 bolt hole pattern to attach to steering column. Fits 1969 to 1972 models 280SL 280SE 280SEL 280SEC and 300SEL.
- 151 reads
Early Model Lug Wrench with Tip to Remove Hubcap (Used)
This lug wrench came with most models from the mid 60s to the late 70's that used the standard hubcaps. The end has a curved tip to allow you to pry the hubcap off.
- 197 reads
112 189 300SE Air Suspension Compressor and Power Steering Pump (Used)
Excellent suspension air compressor and PS pump from a 1965 300SE. Pump has been inspected, cleaned and tested.
- 140 reads
112 189 Steel Coolant Pipe ( Used )
I believe this came off my 189 engine but am not sure. Please review picture closely. Some slight pitting but no major rust through.
- 136 reads
112 189 Manual Transmission Bell Housing Cover ( Used )
Good clean straight lower transmission cover as shown
- 154 reads
112 189 Engine Small Internal Drive Gear
Small gear for 189 engine as shown. Minimal teeth wear.
- 125 reads
112 189 Misc. Engine to Transmission Hardware ( Used )
Set of hardware and cover as shown.
- 130 reads
112 189 Set of Piston Connecting Rods ( Used )
Good used set of original connecting rods from 1965 189 engine
- 133 reads
112 189 Engine Camshaft Oiling Tube ( Used )
Good straight camshaft oiler tube for 189 engine
- 122 reads
112 189 Engine Component Mount Strap ( Used )
From 1965 189 Engine as shown. Application / location unknown.
- 128 reads
112 189 300SE Rear Dunlop Brake Calipers ( Used )
Rare Dunlop Brake Calipers from a 1965 300SE coupe. These have been in storage a long time and will need rebuild kits installed.
- 148 reads
112 189 Late Model Camshaft Rocker Arm Assemblies ( Used )
Good used rocker arm assemblies from a 1965 189 engine that was installed in a 300SE coupe. May bit other years and models of 189 engine.
- 144 reads
112 189 Exhaust Down Pipe to Engine Bracket ( Used )
Good used exhaust header bracket as shown for 189 engine.
- 139 reads
112 189 Engine Fuel Line and Hose Assembly ( Used )
Good used braided and hard fuel line assembly as shown for 189 engine.
- 149 reads
112 189 Engine Lift Bracket ( Used )
Good used 189 engine lift bracket as shown.
- 120 reads
112 189 Adjusting Bracket ( Used )
189 Adjusting bracket as shown.
- 124 reads
112 189 Cast Iron Bracket for Engine ( Used )
Cast Iron 189 Engine Bracket as shown. Not sure of exact application
- 126 reads
112 189 Engine Fuel System Cap ( Used )
189 engine part as shown. Do not know exact application or years.
- 130 reads
112 189 Engine Speed Controller and Bracket ( Used )
Complete part and bracket as shown for 189 engine. Operational electric solenoid.
- 126 reads
112 189 Throttle Linkage Idle Stabilizer ( Used )
Part shipped as shown. Linkage, levers, bracket and idle stabilizer removed from a 1965 189 engine that was installed in a 300SE coupe.
- 116 reads
112 189 Fuel Pressure Regulator ( Used )
Good used regulator from a 1965 189 engine that was installed in a 300SE coupe.
- 118 reads
112 189 Engine Baffle ( Used )
Good used metal heat shield as shown for 189 engine
- 114 reads
112 189 300SE Short Exhaust Manifold ( Used )
Excellent used short section exhaust manifold removed from a 1965 189 engine that was installed in a 300SE coupe. This is an above average manifold with minimal surface rust and good flange and crack free bolt holes. Cast part number is 189 142 04 02
- 113 reads
112 189 300SE Long Exhaust Manifold ( Used )
Excellent used long section exhaust manifold removed from a 1965 189 engine that was installed in a 300SE coupe. This is an above average manifold with minimal surface rust and good flange and crack free bolt holes. Part number on the manifold casting is 189 142 03 02
- 108 reads
112 189 Late Model Fuel Injector Hard Lines (Used)
Good used set of metal fuel injector lines from a 1965 189 engine that was installed in a 300SE coupe. These will fit engines with the 6 element fuel injection pump.
- 119 reads
112 189 Engine Coolant Intake Manifold ( Used )
Good used 189 engine coolant intake manifold. This unit is made out of aluminum and is prone to corrode right next to the through bolts. If you have a 189 300SE you had better have one of these around for a spare. These are a real problem part on these engines.
- 120 reads
112 189 Generator mounting plate with strap ( Used )
Good used generator mounting plate and mounting strap as shown. Removed from later model 189 engine.
- 134 reads
112 189 Fan Clutch and Pulley Assembly ( Used )
Excellent used fan clutch and pulley with mount as shown. Removed from a 1965 300SE 189 engine that was in the process of being restored. Should fit all later 189 engines with this type of engine fan unit.
- 124 reads
112 189 Late Model Cylinder Head ( Used )
Good used cylinder head from late model 189 engine with 6 element injection pump. Removed from a 1965 300SE. No major corrosion in and around water passages and good valve seat areas.
- 122 reads