1970 to 1975 D-Jetronic V8 Fuel Injector Short Hose Replacement Kit

Store > Products
You cut the hose to 8 short 2 inch pieces and use 2 new clamps for each fuel injector

Even if your engine is running "ok," but your hoses are 20-plus years old, you should replace them. 

1970 to 1975 D-Jetronic V8 Fuel Injector Short Hose Replacement Kit
$19.80
SKU:
GEG-DJETINJHOSE

Product Details

Related Products:

$88.50

Bosch D-Jetronic Fuel Injector Service Kit

You will need this if you plan to remove and test or replace the EFI fuel injectors in your 1970 to 1975 Mercedes

This is the most complete 1970 to 1975 V8 injector repair kit you can find anywhere.

$32.00

1970 to 1975 D-Jetronic V8 Engine compartment Fuel Hose Replacement Kit

Full kit. Includes enough hose and clamps to replace all 8 rubber supply fuel hoses. DOES not include the 8 short hoses and clamps for the fuel injectors. See related below.

These engine supply fuel hoses are critical to the well-being of your engine. I have seen too many rotten and deteriorating hoses on these D-Jet engines that could easily lead to an engine fire, and they just do not get replaced when they should.

$129.75

Bosch D-Jetronic Fuel Injector Testing and Cleaning FULL Kit

This includes the required pressure tank for accurate testing. For 1970 to 1975, D-jet electronic fuel injectors - Ready to clean and test your injectors?

This will give you everything you will need ( except 12-volt power and cleaning fluid ) to bench clean and test your D-jetronic fuel injectors in your own garage or workshop once they are removed from the engine.

On Demand Video
$9.99

Early V8 Bosch D-Jetronic Ignition Distributor Inspection and Service - On Demand Video

Problems with this 1970 to 1976 3.5 and 4.5 unique distributor can cause all kinds of engine performance issues.

This is not a complete instructional video on how to "overhaul" the M116 and M117 D-Jetronic fuel injected V8 distributor. There is lots of information out there on installing new points, setting the dwell and timing, replacing the cap and wires, etc.

On Demand Video
$6.99

Tackling a Rough Running D-Jetronic V8 - Initial Inspection and Tests - On Demand Video

Covers Mercedes 3.5 and 4.5 V8 engines from 1969 to 1976

In this video, Kent will walk you through some initial steps you can take to try to solve a rough running problem on an early Mercedes V8 engine with D-Jetronic fuel injection. Please note that this is an introductory troubleshooting video. It does not contain any actual repair information. 

$44.00

1970 to 1975 D-Jetronic V8 Front Engine Short Hose (s) Replacement DIY Kit

You get the hoses, the clamps, the gasket, the sealants and extensive video instructions that will keep out of trouble

If you think your coolant hoses are "ok" they just may be, but it is what is hidden that could be a problem. When you remove those old hoses ( unless they have been replaced in the past 10 years) you may be shocked at what you find.

$24.00

1970 to 1975 D-Jetronic V8 EFI Fuel Injector Tip and Housing Seals

To prevent intake air leaks, replace your aging tip seals and large body seals. You should always replace with new anytime you remove the injectors.

These are the critical seals that go on the D-jetronic fuel injectors. If they leak air, your engine with idle high, start poorly and run lean, which can damage the pistons. We recommend you replace these whenever you remove and replace the injectors.

$16.80

5/16" or 8 mm Fuel Hose Smooth Clamp Set of 16

Rounded edges keep from cutting hose. Best clamp to use for high pressure ( ie. D-Jetronic or other fuel injection )

Excellent quality zinc plated hose clamps as shown. These can be tighten with a straight blade screw driver or a 7mm socket or nut driver.