Search | W108 W109 | On Demand Video

This video will show you how to remove the front crank seal race using the factory tool and using Kent's custom puller. It will also demonstrate a very easy way to install a new replacement race before installing a new seal.

In this 28-minute instructional video Kent with show you how to do a compression test on your own Mercedes gas engine and explain how to interpret the results. It is very important you do this procedure BEFORE "throwing" parts at your engine trying to fix a performance problem.

This video will walk you step-by-step through the proper procedures for doing a full compression test on your older V8 Mercedes Engine.

In this 22-minute instructional video, Kent will take you inside the door on a W123 240D and show you all the key points that should be lubricated and the type of lubricants you should use.

This on-demand instructional video was filmed to go with Kent's new fuel tank sending unit service kit launched in June of 2020. This is not a complete video on the subject of fuel level sending units. For the complete video see related products below.

This highly detailed 37-minute video instruction will show you how to do the following: Determine if your original pump needs replacing, drain the fuel out of your fuel tank, remove the old pump assembly, take it apart on the bench and install the new pump, filter, and hoses, and properly reinsta

When the motor won't move the window down you can not get to the bolts that hold the regulator to the glass. So then how can you get it out of the door!  What a pain! In this xxx minute video Kent will show you what you need to do in order to get a "stuck" power window regulator out of a door.

This video will not only save the condition of your door panel, but it will save you a lot of time and frustration when you go to replace a door panel after doing maintenance inside your door. Those old plastic film liners always seem to be torn, ripped, and downright ugly.

Kent video instructions will take you through the process of flushing out the old automatic transmission fluid and replacing it with modern enhanced power steering fluid. This procedure was filled on a W108 280SE 6 cylinder sedan.

This is a full 25-minute step-by-step instructional video on how to properly flush or bleed your brake system using our pressure brake bleeder and fluid capture tank.

Kent came up with this kit because of all the times he replaced e-brake shoes only to end up with battered knuckles and extreme headaches. This video is included free with the purchase of the toolkit.

Have you dreaded changing the rear end fluid before because it is a pain and ends up being really "messy?" Kent finally decided there had to be a better way so he went to work and came up with the idea of using a simple and affordable custom made pressure tank to "flush" and refill differentials

This is not a complete instructional video on how to "overhaul" the M116 and M117 D-Jetronic fuel injected V8 distributor. There is lots of information out there on installing new points, setting the dwell and timing, replacing the cap and wires, etc.

Learn all the tricks to adjusting the valves on your older Mercedes V8 engine.

In this video, Kent will walk you through some initial steps you can take to try to solve a rough running problem on an early Mercedes V8 engine with D-Jetronic fuel injection. Please note that this is an introductory troubleshooting video. It does not contain any actual repair information. 

One of the most often neglected easy and inexpensive maintenance items I see on gas engines. Why do people think that spark plugs will last forever or that it doesn't matter what type of plug is used! Aren' they all created equal?

Kent will show you the proper way to remove and replace a V8 valve cover gasket so you won't have oil leaks after installing a new one. This is a common maintenance item.

This on-demand training video will walk you through the steps you need to follow in order to get your headliner panel off so you can work on the sunroof. If your sunroof won't open, you are stuck - right? Not SO according to Kent.

In this video instruction Kent will show you how he installs our battery tender kit in a W124 Mercedes.

This 28 minute on demand video manual will take you through the step-by-step procedure for taking the upper (motor section) of a short MFI fuel pump apart and replacing three o-rings that are prone to hardening and leaking fuel.

These are the instructions that come with Kent's brake pad and brake caliper service kit. It is possible to make your own service kit by watching this video. To purchase the kit see related products below. To learn more about the importance of this kit watch the video below:

Valve adjustment is often neglected on many of the mid 1950's to early 1970's 6 cylinder single overhead camshaft gas engines.  If it has been years since any adjustment was made, there will be problems - Kent can guarantee it!!!

If your engine is just running hot, it may be due to a plugged radiator or possibly a stuck thermostat. If your engine is just losing coolant it could be a leak in the water pump, radiator or hoses.