Recently Added Products

Stop those water leaks now! This high-quality rubber trunk seal fits all sedans with W126 chassis from 1981 to 1991, both gasoline and diesel. It now comes with complete instructions loaded with tips. We recommend E6000 adhesive, which can be purchased separately below.

Fits all models from the late 1960s up to the early 1990s that use a contact grounding spring inside the front hub bearing grease caps. Sold as a set of two (2). This important copper spring provides a clean contact to ground for the brake pad sensor wire.

New set of upper and lower radiator hoses that fit 1981 to 1985 300SD, 1981 to 1985 300TD, and 1982 to 1985 300D and CD (turbo engines only). NOTE: Does fit SOME late-model 240D.

This is the number one cause of a sharp engine rattling noise at idle on the early 602, 603 and 604 engines. It is not that the shock goes bad, but the bushings car wear out prematurely due to harsh vibration and the ends of the shock will make a terrible noise inside the loose bushing.

New inside passenger compartment hood release handle and mounting plate. This fits all 116 chassis sedans from 1973 to 1980 and all 126 sedans and coupes (SEC) from 1981 to 1991. Check yours for cracks now before it completely breaks off!

Genuine Mercedes special o-ring set to repair the leaking brass heater valve levers on your 1967 to 1973 108 / 109 sedans and 1968 to 1976 114 / 115 sedans and coupes. These are not your normal orings. These are a custom design made specifically for the heater valve control barrels.

New intake manifold gasket between head and manifold.

You should consider replacing this gasket when you remove your manifold to replace the glow plugs. Fits all 602 5 cylinder diesel engines from 1986 to 1993. 

New Genuine Mercedes engine shock bushing kit. Helps to reduce engine shake and vibration. Fits all 300SD both 116 and 126 from 1978 to 1985.

If you also need the engine shock look below to order.

New Febi Bilstein OR Stabilus brand Engine Shock. Helps to reduce engine shake and vibration. Will also fit some later model non turbo models. Fits all 300D, 300CD and 300TD 1982 to 1985.

New Behr Thermostat and sealing ring rated at 87 degrees C. Correct fit for all 201 and 124 chassis 4 and 6 cylinder gasoline engines from 1984 to 1993. Most thermostats only operate at peak efficiency for few years and should be changed for optimal engine performance.

Good used, diesel only, trunk emblem for 123 sedans, coupes and wagons. That includes: 1977-1981 300D, 1977-1983 240D and also 1977-1981 300CD. Also, 1978-1980 only 300TD wagon. The emblem was removed properly and is not bent and all three mounting pins are intact. 

This is the unit that keeps your serpentine belt properly tensioned. This is a common part to see wear out in the 120,000 to 150,000 mile range. When it does, your belt will become loose leading to belt noise, overheating, and poor alternator output.

In stock and ready to ship. New aftermarket fan clutch replacement for 113,111, 108 and 109 chassis gas engines from 1968 to 1973, all 114 and 115 gas and diesel, all 123 gas and diesel engines 1977 to 1983 and 1981 to 1983 126 300SD.

Emergency brake shoe maintenance is often neglected because the rear brake disc / rotor has to be removed to inspect and repair them. If the car has ever been driven a long distance with the emergency brake on, expect problems.

Fits all Mercedes models with the 14" Alloy bundt cake style wheels. The measurements are M12x1.5mm by 51mm overall length. This is a set of five brand new silver lug bolts.

Fits all GAS ENGINE exhaust systems for W107, W116, W126, W124 and W201 chassis from 1972 to 1995. Gas engine exhaust systems are generally heavier and run hotter than diesel engine exhaust systems. This is a wider and more heavily reinforced exhaust hangar than the standard round type.

This part controls the function of your backup lights as well as the starter motor lock-out if you do not have the transmission selector in park or neutral. It is called the neutral safety switch and fits all 107, 114, 115, 116 and 123 chassis to 1981 (except 81 Turbo wagon).

New OE Reinz head gasket set. Fits all 115 and 123 300D 5 cylinder non-turbo engines 1975 to 1981. Comes complete with all gaskets only as shown in the picture. Valve stem seals and valve cover gasket are NOT included.

COHLINE BRAND 

Set of (2) new rubber hood stop buffers to adjust the front corner closing of our hood. You will normally see the rubber ends missing, hardened or cracked. Replace and properly adjust for better hood closure. Fits all models that use stop buffers from 1963 to 1993.

If your pan plug is worn, leaking or rounded off, dont fight it anymore! Buy a new pan plug and copper sealing ring and stop those unsightly oil drips now. This is the small 13 mm head factory pan drain bolt that came on 240D, 300D, 300CD, 300TD and 300SD from 1974 to 1985

Brand New Reutter Expansion Tank Cap marked 140. This fits all 201 chassis 190E and 190D from 1984 to 1993 and all 124 chassis sedans, coupes and wagons from 1986 to 1995 both gas and diesel. A worn expansion cap is the number one reason for very gradual coolant loss.

Fits all 123 chassis sedans, coupes and wagons from 1977 to 1985. This is the complete kit for the right passenger side front or rear door. It includes a new striker, four new Mercedes OE Allen bolts, special removal tool and instructions.

This is a brand new 3 way Vacuum change over valve. It is located in the engine compartment on a number of different chassis Mercedes, both gas and diesel models, from the 70s up through the late 90s.