Set of four (4) new factory door striker bolts. It is very easy to round these off. If you are planning on removing or adjusting your strikers and want the original style hex bolts you should have extras on hand.
New complete hood cable assembly for 123. Take a close look at yours to see if it is kinked near the pull handle. Might want to replace it BEFORE it breaks off on you. Comes with new firewall grommet. Lists for $32.50!
New ATE clutch cylinder fits all 190D and 190D with manual transmissions from 1984 to 1993.
New Ate Clutch SLAVE cylinder for early 123 chassis 240D manual transmission. Be sure to check your vin number before ordering. This one fits up to the following vin number 123.123 - up to 219674. List price is $ 107.00
Stop those water leaks now! This high-quality rubber trunk seal fits 116 sedans (Gasoline models ONLY)from 1977 to 1980, including the 280SE, 450SE, 450SEL, and 450SEL 6.9. It now comes with complete instructions loaded with tips.
SPECIAL ORDER ITEM. WILL NOT FIT OTHER MODELS! Correct transmission filter and pan gasket that fits. This one is hard to find and you can easily get the wrong one ( it is very close to the early 123 diesel service kit.
This 5 piece set is made out of plastic so it will not mar or scratch paint, glass, chrome trim, etc.
New Bremi distributor rotor fits models listed above from 1986 to 1991. Check yours now for heavy burn marks or arcing.
New Bosch OR Bremi brand distributor cap fits models listed above from 1986 to 1991. Check yours now for cracks or arching.
Good used black plastic intake air grill for driver side. Fits 1977 to 1985 sedans, coupes and wagons. Three clips are included. One is missing.
Good used front seat back tilt adjusting knob with all three tabs still intact. One or more of these three tabs often gets broken off when removing - making for a sloppy and loose knob. Check to make sure your current knob matches this design.
Excellent used condition. No cigarettes ever look like they were in there. Very clean and very clean contacts on cigarette light. Notice the type of electrical plugin on the left side to make sure it will plug into your wiring. Rare find. Vinyl cover is like new.
NOTE: STYLE MAY VARY. This will not be the actual check valve you will receive. Excellent used diesel fuel check valve for four and 5-cylinder diesels from 1977 to 1985. This valve is mounted inside the injection in line going to the filter.
New intake manifold gasket between head and manifold. You should consider replacing this gasket when you remove your manifold to replace the glow plugs. Fits all 601 4 cylinder diesel engines from 1984 to 1986.
New intake manifold gasket between head and manifold. You should consider replacing this gasket when you remove your manifold to replace the glow plugs. Fits all 603 6 cylinder diesel engines from 1986 to 1995.
On its way to becomming NLA.New Bosch pre-pump that mounts on the side of the injection pump. This is what makes your 60x. The engine is self-priming and delivers fuel pressure to the injection pump.
New heavy duty water pump complete with gasket that fits all 190D 2.5, 124 chassis 300D, 300TD and 300D 2.5, 126 chassis 300SDL and 350SD and SDL, and 140 chassis 300SD and S350D. No instructions at this time.
Brand new Gemo Speedometer cable for all 5 cylinder 123 Chassis Diesels from 1977-1981. If any question that this single length cable will work in your car please measure your existing cable. This one measures 1460 mm. This only works on non-turbo automatic transmissions.
Yes, with age, they can leak from the inside out ever so slowly. Replace before they fail! This is a great upgrade that fits most models from the early 70s up to the mid-to-late ' 90s. The wire protector on these hoses will prevent chafing, especially from loose V-belts.
New Graf Water Pump with seals. Do not go to the trouble to replace your 103 engine water pump and buy a cheap after-market brand.
Stop those water leaks now! This high-quality rubber trunk seal fits all sedans with W126 chassis from 1981 to 1991, both gasoline and diesel. It now comes with complete instructions loaded with tips. We recommend E6000 adhesive, which can be purchased separately below.
Fits all W123 240D 300D and 300CD 1977 to 1985. Are you finding standing water in your trunk? Stop those water leaks now! High quality rubber trunk seal. Fits all 123 Chassis Sedans and coupes from 1977 to 1985, including 240D 300D 300CD 280CE.
Fits all models from the late 1960s up to the early 1990s that use a contact grounding spring inside the front hub bearing grease caps. Sold as a set of two (2). This important copper spring provides a clean contact to ground for the brake pad sensor wire.
Fits all 116 sedans 1973 to 1980. A dried out and cracked rear window seal is the number one reason for water leaks into the trunk compartment. There can be others but this should be the first on your list. Very difficult to successfully caulk an old seal.
New set of upper and lower radiator hoses that fit 1981 to 1985 300SD, 1981 to 1985 300TD, and 1982 to 1985 300D and CD (turbo engines only). NOTE: Does fit SOME late-model 240D.
We include a chaffing guard for the lower hose.
Brand new oil pan repair kit. Includes new pan, new pan gasket, and new oil drain plug. Fits 115 chassis 220D, 240D and 300D. Also fits all 123 chassis non turbo 300D diesels from 1977 to 1981, and 240D from 1977 to 1983. Gasket and drain plug included, but not shown.
This is the number one cause of a sharp engine rattling noise at idle on the early 602, 603 and 604 engines. It is not that the shock goes bad, but the bushings car wear out prematurely due to harsh vibration and the ends of the shock will make a terrible noise inside the loose bushing.
LAST ONE WE HAVE! Rear suspension hydraulic fluid reservoir filter holder and used filter as shown. If you need a new filter to go with it, see below.
This is a very good pump with signs of reasonably low wear. It is hard to tell for sure but it appears to have been installed on a rebuilt engine with only about 10,000 miles on it.
Leaking fuel injector pumps have become a very common problem in the 60x. engines produced from the mid 1980s to the mid 1990s. The early 60x.
New inside passenger compartment hood release handle and mounting plate. This fits all 116 chassis sedans from 1973 to 1980 and all 126 sedans and coupes (SEC) from 1981 to 1991. Check yours for cracks now before it completely breaks off!
Brand new OE Genuine Mercedes battery tray for your 123 chassis all models 1977 to 1985.
If there is a lot of rust under your tray be sure and check out our Miracle Paint to seal the rust forever!
Very good used working power sunroof switch for all 300SD and all 300D 300CD 1981-1985. It will also fit 380SE and 380SEL. Notice the lack of wear on the switch face!
This is a good used aluminum water pump housing that fits all OM617 5-cylinder turbo diesels from 1978-1985. This includes the W116, W123, and early W126 chassis.
Excellent used air filter neck, along with good flexible rubber connector flex boots as shown . May or may not have all clamps - only 2 available.
Genuine Mercedes special o-ring set to repair the leaking brass heater valve levers on your 1967 to 1973 108 / 109 sedans and 1968 to 1976 114 / 115 sedans and coupes. These are not your normal orings. These are a custom design made specifically for the heater valve control barrels.
New valve cover gasket for 602 5 cylinder diesels.
Should be replaced anytime you remove the valve cover for inspection or valve train maintenance.
New intake manifold gasket between head and manifold.
You should consider replacing this gasket when you remove your manifold to replace the glow plugs. Fits all 602 5 cylinder diesel engines from 1986 to 1993.
New OEM high quality air filter. Fits 1990-1993 300D 2.5 and 1995 E300D only.
Good used 4.5 emblem. This emblem is located on rear of the trunk on the right side of all 280SE, 280SEL, and 300SEL 4.5's produced between 1971-1973.
New Genuine Mercedes engine shock bushing kit. Helps to reduce engine shake and vibration. Fits all 300SD both 116 and 126 from 1978 to 1985.
If you also need the engine shock look below to order.
New Stabilus engine Shock. Helps to reduce engine shake and vibration. Fits all 300SD both 116 and 126 from 1978 to 1985.
If you also need the mounting bushings and hardware kit look below to order.
The bushing is as important as the shock in dampening out excess engine shake and vibration.
New Febi Bilstein OR Stabilus brand Engine Shock. Helps to reduce engine shake and vibration. Will also fit some later model non turbo models. Fits all 300D, 300CD and 300TD 1982 to 1985.
Brand new expansion tank fits all 201 chassis 190D and 190E 1984 to 1993 and 124 chassis 260E, 300E, 300CE and 300TE 1986 to 1992 only.
Be sure to add a new radiator cap!! Look below to order.
New Behr Thermostat and sealing ring rated at 87 degrees C. Correct fit for all 201 and 124 chassis 4 and 6 cylinder gasoline engines from 1984 to 1993. Most thermostats only operate at peak efficiency for few years and should be changed for optimal engine performance.
This is a very important maintenance item for all 116 and 123 chassis 617 5-cylinder turbo diesel owners.
Good used, diesel only, trunk emblem for 123 sedans, coupes and wagons. That includes: 1977-1981 300D, 1977-1983 240D and also 1977-1981 300CD. Also, 1978-1980 only 300TD wagon. The emblem was removed properly and is not bent and all three mounting pins are intact.
Good used 300D trunk emblem. Fits all 300D sedans from 1977-1985. Was removed properly and not damaged.
This flexible accordion section of the pipe is prone to breaking with age. When it cracks, you will hear a change in your exhaust sound and will notice black soot staining where it is leaking. One end bolts on the rear of the turbo.