Removing Rounded Out or Damaged Hex Head Bolts

Avoid the pain of having to drill or cut the bolts off

Mercedes Benz used a number of hex head (Allen) bolts on their passenger cars, particularly in and around the engines. If you work on Mercedes for very long you will eventually be faced with the dreaded hex head bolt that will not come out. It usually happens on the last one you are removing when doing a repair!

Problem & Solution

Common among these chassis:

Classic Sedans
Ponton
R107
W108 W109
W110 W111 W112 Sedan
W111 W112 Coupe
W113
W114
W115
W116
W123
W124
W126
W201

The problem usually comes from rounding out the hex head with the Allen wrench. It always seems like the wrenches are just not tight enough. If you don't know how to deal with this, a small job can turn into a huge headache!  Here are some tips to help you prevent the problem in the first place and on how to deal with it, should it happen.

PREVENTION: Here is a list of things you should do to prevent rounding out a hex head bolt

  • Always thoroughly clean down inside the hex head hole. Use a pick or small screw driver to clean out debris.
  • The wrench must fit tightly all the way down into the head of the bolt. Don't use worn wrenches
  • Try to HIT the head of the bolt with a hammer and punch before attempting removal
  • This shock treatment helps to slightly loosen the grip of the bolt head to the surface
  • Don't use a slow turning motion with the wrench. This can actually increase the chance of rounding out the head.
  • Rather, use a quick snap or jerk of the wrench to break the bolt loose

CURE:  If it still happens here are some options for bolt removal

  • If the damaged bolt is out in the open try grabbing the head with a pair of vise grips to loosen it.
  • As an alternative use a sharp chisel and hammer. Catch the edge of the head with chisel and hammer the head counter clockwise.
  • Use torx or star bits. This has become my favorite method. You may have to grind or modify the tip to get it to fit tight. See notes below:
  • If all else fails you will have to drill the head of the bolt off. Rent a right angle drill if space is limited.
  • Motor mount bolts (particularly 116, 123 and 126 chassis) - you can not get to the heads on some of these as they are up inside a hole in the subframe. If you can not get them out with a star socket or oversize hex then you will have to drill the head off and find a good used replacement motor mount arm...

Notes on using socket drive Torx bits:

I always have a set of torx bits in my tool box of hex head bolt troubles (see picture above).  You need to find a torx bit slightly larger than the bolt head size. Then you can drive the bit into the head of the bolt with a hammer for a super tight fit. This may require that you modify the torx bit on a grinder. You can grind the sides off slightly or as in the picture below, you can grind off the tip to get the bit to fit tightly in the damaged bolt head.  This really works.  I love my torx!