Search | Used

DESCRIPTION: Excellent used combination turn signal, high beam and wiper switch assembly. Note no cruse control level included. Easy to install buy pulling wiring bundle right out through the steering column. There will be some wear on the handle.

This is a genuine Mercedes used part. These are much stronger than the aftermarket ones available. Genuine are no longer made. No damage to the slot or the threads. Only for models listed. Does not work on later aluminum diesel engines. Collar nut holds pre-chamber in cylinder head.

Description: For 250S 250SE 280S 280SE 300SE 300SEL for years noted in subtitle. Good used
Good straight used headlight ring
With Screws
Fits upper or lower headlight

Description: For 220S, 220SE, 300SE, 300SEL, 250S 250SE 280S 280SE 300SE 300SEL for years and chassis noted in subtitle with US style twin vertical sealed beam headlights. Excellent Used above average condition. No dents or cracks. Very bright chrome with no flaking

Good used turbo charger center section to turbine housing hold down ring plate as shown. This only fits the Garret T3 Turbo. Will not fit the KKK turbos. Will not fit 1985 models with trap oxidizer.

Good used turbo charger compressor housing as shown. This only fits the Garret T3 Turbo. Will not fit the KKK turbos. Will not fit 1985 models with trap oxidizer.

Check closely that these match your current hardware. This would be a good set of slides if your hardware is severely rusted or plastic is broken

Good used PASSENGER-side rear taillight lens assembly. Above average condition. There are no breaks in the plastic lens. NO BULB HOLDER included. Good used seal included.

Common breakage item on W123 sedans and wagons. Plastic lock pull knob screws onto this rod. For right or left rear door.

Good used condition. Light bulbs not included

Very nice used driver side taillight bulb hold complete with attachment locking tabs. Can not guarantee bulbs. If you are having tail light problems with could be the problem (loose wiring and corroded sockets).

Right rear pin and slide as shown. This is a common rust part and the threaded pin must be removed to remove the sunroof panel. This pin also rides up on a ramp to close the rear of the sunroof flush with the roof.

This is an original first aid kit. It came out of a 1981 300D.  Contents look mostly complete and are original. I have 2 so it may or may not exactly have everythings inside as shown below.  It probably should not be used as a first aid kit. This should be for original cosmetic purposes only.

Above average condition drivers outside mirror - good working adjustment mechanism. Good glass and chrome. Not perfect but very usable and presentable. May need a little flat black paint touchup on the face frame. Will not fit coupes.

Very Good used trunk emblems and star as shown. They are very straight and plating is bright. The handle has one very small ding in the bottom center.

Often missing or badly rusted. These are two good "restored" originals that are used to hold down the battery to the original tray. Fits 123 chassis from 1977 to 1985 280E 280CE 240D 300D 300CD and 300TD.

In working on many 61x series diesel engines, I have often found one or more of these clamps missing. Missing or loose clamps are the number one reason for injector hardline crack failure. There should be a clamp like this between every two hard lines to minimize vibration fatigue failure.

Good used passenger side rear bumper end rubber. Mounting plate sold separately

Very good used chrome trunk star. No corrosion or pitting. Fits all 300SD. 380SE, 380SEL, 500SEL 1981 to 1985.

Good black plastic trim cover. Installs behind chrome door pull. Fits 1981 to 1985 300SD and other 126 sedans

Good used bright aluminum trim ring. Goes around ignition key tumbler assembly. Complete with three tabs intact. No rubber seal. This is not perfect as there may be some small scratches, but it yours is missing this is much better to look at than a hole through your dash.

Fits all 123 sedans, coupes and wagons 1977-1985 with air conditioning. These are the brackets that hold the aux. electric fan in place. If you have been in a front end hit you will most likely need to replace these bars.

Fits 116 123 126 4 and 5 cylinder non turbo and turbo engines 1977 to 1985. Good used set of five special factory stretch bolts that hold the rocker arm towers to the cylinder head. Common damaged item and hard to find new. The 5 bolts here will work with 5 cylinder engines.