Hi All,
Used Kent's handy manual/kit for the Monark Injector Nozzle swap. Am in the
middle of the job... two of the injector nozzle bodies don't seem to want
to come out (the other 4 came out pretty easily). Ditto for several of the
shims... some blew-out with a little blast of air/solvent... the others
are sitting tight.
Any suggestions? I've tried "liquid wrench" on the nozzle bodies... so far
no luck.
I was surprised that one of the nozzles was way more rusty than the others;
also, if any of you are contemplating/preparing for this job, I'll save
you the puzzlement: sometimes the crush washers/heat shields come out with
the injector body... so you don't have to sit there scratching your head,
wondering why some are longer than others... Doh!
Cheers.
Bill M.
Mountain View, CA
http://picasaweb.google.com/buixote/Injectors#