This can be installed in your diesel in 60 to 90 minutes. You will use the video instructions for installing it in a W123 (included), then you will make location modifications to fit your specific chassis. It is not possible for us to show the individual installation in every single model. Use your creativity and install it the way you want! Watch Kent's YouTube video below, and he will show you the installation variables.
Product Details
NOTE: These special kits are assembled to order. Please allow 3 to 5 days before expecting it to be shipped. Kent first learned about the advantages of using a low-pressure fuel boost pump on an old diesel when he was converting those engines to run on straight vegetable oil. Want better starts, more power, easier fuel system maintenance? Watch the YouTube video below for a demonstration and full explanation.
The kit comes partially prewired and assembled, 90 percent ready to install. This will save you one to two hours of time depending on your electrical wiring skills. There is no cutting into the original wiring, and you only need to drill three small holes in the left side inner fender panel ( you could glue the parts on with E6000 if you did not want to drill and remove the parts later).
Extra-long battery wire, 5/16 inch fuel hose, and extra clamps are included, providing enough for almost any installation.
The entire installation installs in the engine compartment with easy access. You will not need to work in the back of the car nor will you need to raise it up.