W110 W111 W112 Sedan, BENZ AID - COMMON QUESTIONS AND ANSWERS

Putting gas in a diesel - What happens?

Hi there. Just was curious about what exactly would happen if someone filled a diesel cars tank with normal gasoline. I know this is a bad idea. I'd NEVER do it, of course. Just was wondering what the effect would be. It's bound to have happened by accident at a full service station to someone. Would it start? Run? Explode? Would this make for a fun filled, exciting episode of "Master Blasters"??? Anyway, was just wondering and hoped someone would know. Thanks so much... NSA - Hazleton, Pennsylvania, U.S.A.

Forums

Diesel Engine Specific Aid

1980 450sl heater / ac problems

I have a 1980 450sl and just replaced water pump thermostat and servo unit and catilytic converter and left and right side pipes. Runs gr8 but when i turn on a/c it starts out ice cold working well and blowing fine, but after about 5 to 10 mins it starts to blow heat. wondering if you might can tell me what to look for. tks MCTurner

Forums

Body and Interior Specific Aid

Taxonomy upgrade extras

Questions and Answers

Chassis Model Number

R107

83 300TDT non start

I was tyring to track a problem with slow engine shut-off and have solved the problem so completely that the engine is now totally stopped. While running my car with the shut off valve actuator disconnected from vacuum, a gauge on the line that supplies vacuum to that actuator and the ignition shut off to measure vacuum supplied to the actuator, the car slowly built to about -5lbs before the car rattled to a stop. The shut off valve actuator was disconnected from vacuum. The car will now crank but is not getting fuel (apparently). I have verified that there is no fuel at the return line when car cranks, no fuel moving in the prefilter. I have removed and checked the shut off actuator and shut off linkage. They are all moving freely and properly.

Chassis Model Number

W123

Forums

Diesel Engine Specific Aid

1984 300D 123 Rear Axle Flange Removal How?

I have a 1984 300D 123 chas that I was replacing the rear Axles on. I ran into a problem. I did a rush job while trying to take the right rear axle out. I took the tire off, then removed the 13mm long screw from the center of the hub, then I messed up when I tried knocking the Axle Shaft out with a crow bar. The curved crow bar banged into the grooves of the Axle Shaft Flange. So when i try to put the new axle on it wont go, because I destroyed the grooves.

Forums

Body and Interior Specific Aid

Taxonomy upgrade extras

Instructions

Chassis Model Number

W123

Miracle Paint and a Leaking Radiator

Total KUDOs to the makers of "Miracle Paint"!!!! I went through 2 separate kits of plastic repair stuff on my radiator at the radiator neck. The last person to replace the hose cracked the radiator by pulling side-to-side on the hose. Now I have a seam crack 3" down the side of the plastic housing, and at the inside of the elbow. I decided to try the "Miracle Paint" with the standard fiberglass cloth. - put one coat of paint on the crack + 1" either side of the crack, - allow it to sit 15 minutes, - apply the fiberglass cloth, press it down so that it is tight against the crack and surrounding area, and - apply another coat of "Miracle Paint". - Let it dry overnight - Apply a 3rd and 4th coat of paint and let this dry 12-24 hours between coats.

Forums

Body and Interior Specific Aid

Taxonomy upgrade extras

Tips

Chassis Model Number

W124

Pages