These bushing go on either side of the upper control arm where it attaches to the stabilizer arm. These should be replaced if worn or installed new upper control arms. SOLD IN A SET OF 4 as required by car. See related products below for the upper control arms that these bushing fit into.
Product Details
Location of upper control arm bushings on car
Related Products:
1977 to 1985 Mercedes W123 Front End Ride Restoration Kit
SAVE BIG! These critical front suspension parts will restore the factory road feel on your old 123. Watch the video as Kent will explain what they are, where they do, and what is involved in replacing them.
This kit contains the following new parts:
W116 and W123 Upper Control Arm Set
New left AND right side upper control arms. They will fit ALL W116 chassis from 1973 to 1980 ( except 6.9 ), and ALL W123 chassis sedans, coupes and wagons from 1977 to 1985.
126 Chassis Left (Drivers side) Front Suspension Upper Control Arm
This is a very common wear item on high mileage 126 chassis. It will start out as a clunking noise when you go over rough ground. When real bad it will be hard to get your car to track right down the road (it will want to wander) and you will experience rapid and uneven tire wear..
126 Chassis Right (Passenger side) Front Suspension Upper Control Arm
This is a common wear item on high mileage 126 chassis. It will start out as a clunking noise when you go over rough ground. When real bad it will be hard to get your car to track right down the road (it will want to wander) and you will experience uneven and rapid tire wear.