Emergency W123 and Early W126 Diesel Motor Mount Bolt Removal Tool

Store > Products > Specialty Tools
If you "round out" the hex hole in the main engine mount bolt this is the easiest and fastest way to get the damaged bolt out.

You must drive this star bit into the head of the damaged bolt with a hammer, but it will hold. The bolt will then need to be replaced. Watch the video below as Kent will explain how it works.

Emergency W123 and Early W126 Diesel Motor Mount Bolt Removal Tool
$3.90
SKU:
TUL-EMOTORMOUNT

Product Details

Kent shows how and where it is used

For mount kits and hardware, see related products below.

Related Products:

$22.50

115 116 123 and 126 Diesel Motor Mount Installation Help Kit

Instructions and special ratcheting hex tool and small combination wrench included 220D 240D 300D 300CD 300TD 300SDL

This kit will work on all 115, 116, 123 and 126 chassis diesels from 1969 to 1987. Almost every old Mercedes diesel I see needs to have the motor mounts changed. If you have a mechanic do it for you it will cost an arm and a leg.

$54.20

W123 Chassis 5-Cylinder Non-Turbo Diesel Motor Mount Kit

For all non-turbo 300D 300CD 300TD models 1977 to 1981 includes transmission mount

Have you noticed your Mercedes diesel sedan is recently shaking more at idle. Maybe you are noticing new vibrations that were not there before. You may have also noticed the engine makes some clunking noise when you shut it off. When was the last time your rubber motor mounts were changed.

$76.50

W123 Early W126 Turbo Diesel Motor Mount Kit with Free Instructions

Installation tools as shown included. For 5-cylinder Turbo Diesel Engines ONLY 1981 to 1985

FITS THE FOLLOWING: 123, 126 Chassis 300D 300CD 300TD 300SD (from 1981 to 1985) with 617 5 cylinder turbo diesel engines. Have you noticed your Mercedes diesel sedan is recently shaking more at idle? Maybe you are noticing new vibrations that were not there before.

$13.75

W123 W126 OM616 OM617 Diesel Motor Mount 8mm Heavy Duty Long Socket

Made in Taiwan. Very hard steel. This is a sharp edge impact socket for maximum strength. For most diesels 1977 to 1985 except W116 300SD (requires 10mm)

Removing the front rubber engine mounts requires getting under the car and going up inside a hole in the subframe to remove the main bolt. And it can be a bear! I don't know who they hired to tighten these at the factory, but he must have been a brute.