$26.50
W126
adjusting valves in 85 300sd
I have a 1985 300sd and have been told that this year has self adjusting valves, is this correct or do i ned to adjust them myself, thanks mitch
Forums
Taxonomy upgrade extras
Chassis Model Number
84 300SD Battery Drain
Anyone know how to diagnose a battery drain in a 126- 1984 300SD? I just bought this car a few months back with a new battery. I guess I know why the guy who sold it to me put a new battery in right before he sold it......
The car starts when jumped. The battery is 3 months new. I tested it with a multimeter. After sitting for the night the battery is around 10. After its jumped the battery reads 13.5. The alternator is fine as far as I can tell. Never died on me while I was driving and the battery charges while the car is running.
Chassis Model Number
Forums
'84 300SD driver's seat
I'm wondering if there's anyone out there that has had a seat motor go bad? I have replaced the seat switch on my driver's side to no avail and am wondering where to go next. I can hear the switch make a noise when I move it so I am assuming that is in working order. I have both of Kent's manuals (Chassis Door Maintenance and Repair & Front Seat Repair and Restoration) and neither speak directly to my situation. However, they do a wonderful job in describing how to remove the front seat, which I'm slightly afraid that's where I'm going to have to go to next!
Chassis Model Number
Forums
$12.95
Sedan / Wagon Door Seal Instructions and Tools
There are some tricks to getting a replacement seal in properly
Monark Nozzles for 87 300SDL
Hello,
Could someone tell me which of the Monark injector nozzles can be used on a 87 300SDL (603 engine)? I am going to be running some SVO and these look interesting but my model is not listed.
Other information leads me to believe either may work - any opinions?
Thanks
Richard
Chassis Model Number
Forums
$58.50
Diesel Fuel Injector Tuning Manual and Top Brass Tool Kit - Combo Special
Best tool kit to clean the insides of your old fuel injectors. You might get them to spray well again without buying replacements
$18.95
Diesel Injector Cleaning, Overhaul and Testing Procedures Manual - by Kent Bergsma
BACK IN PRINT! MARCH 2025
Locked Door Fix
I unscrewed the door lock button from a rear door and heard this terrible noise... the clinking of something falling down into the door. Now it seems obvious that the threaded rod that initiates the lock/unlock mechanism has fallen into the door. The problem is the door is locked and I am unsure as to how to get the door panel off to fix this. Can the lock be picked by a rookie or am I going to have to get a locksmith to open it? Why would it fall into the door unless it is not attached? Any ideas would be appreciated.