$9.25
Crank Pulley Removal Heavy Duty Hex 6 mm Socket
Fits 6 bolts on front crank pulley set on 240D 300D 300CD 300TD 300SD 1974 to 1985
W116, Manuals by Kent Bergsma
$28.50
615 616 617 Diesel Engine Injection Pump Timing Drip Tube
For setting Injection pump timing per factory manual.
Interior
Inside Door Related Problems
Failure to do preventative maintenance could lead to some very expensive repairs
1980 W116 Rear Axle Shaft Mounting C Clips Installation ??
I have found getting these little clips on the axle while on my back under the car incredibly difficult. Any helpful hints on how to get this clip on the axle? Any tools that would help?
Chassis Model Number
Forums
1979 300SD - Rear end CLUNK when turning ??
Two days ago, when over a bump and the car "creaked".
This morning, when I turn or take a curve, a big CLUNK-CLUNK-CLUNK from the rear the car.
What could it be?
Chassis Model Number
Forums
Body and Exterior Trim
Finding your Mercedes Factory Paint Color Code
This can sometimes be a real challenge if you do not know where to look
Interior
Drooping or Floppy Sun Visors
There is a simple fix to keep those old sun visors up
1978 300SD sway bar bushing location ??
Hello,
I'm getting a clunking noise in the front end when I go over bumps. I poked around underneath and couldn't find any play or wear anywhere, so I took it to a local shop. The mech said I've got a bad sway bar bushing, and it's "impossible" to get at. He also said it's not worth fixing since it's not dangerous as is. Is he right? Anyone else have a similar problem with this bushing? I'm considering going to another shop for a second opinion, since this could be a safety issue.
Thanks!
Chassis Model Number
Forums
1980 300SD Bent voltage regulator
I removed my voltage regulator and when I took it out it looked like the attached image. Basically one brush at an angle and touching the other brush. I just put the new one it but after screwing the new one in I'm a bit confused as to how the old one got the one bent brush. Any ideas? Was it just a cheap part? There was no brand on it at all.
I guess this might get removed but images make it so much easier to show what is going on.
Matt
http://i.imgur.com/gFX2Z.jpg
Chassis Model Number
Forums
$14.95
Engine Coolant Temperature Sensor
SINGLE pin - located on left side of cylinder head by glow plugs on 1977 to 1985 OM616 and OM617 Diesel engines.