$9.75
Genuine Brake Pad Paste ( 2 Pack )
Applicable for all models with disk brakes
W116, BENZ AID - COMMON QUESTIONS AND ANSWERS
1983 300SD vacuum locks but not unlock
I have gone through the vacuum lock lines and tested each door to make sure I dont have a leake. The doors will all lock when the drivers door is pushed down from inside or with the key. But will not unlock the other 3 doors when the drivers door is opened. The trunk lock holds vacuum but does not unlock other than with the key. When I push the drivers door down the motor in the trunk comes on and goes off. When the drivers door is opened (lock pulled up) is the motor in the trunk to come on and push air to the other 3 doors to unlock them?
Thanks for your help Jim Hunt.
Chassis Model Number
Forums
1982 240D Abnormal inside both tire wear ??
Hi. Wanted to get your idea on why I would be getting abnormal tire wear on the inside of BOTH tires. I do have some steering play which I attribute to needing either new idler arm bushings, which I just ordered or perhaps in need of a reconditioned steering box. However, I can't see this causing the inside of both tires to wear. Is it possible the camber is set too far somehow? Thoughts?
Thanks
Dave
Chassis Model Number
Forums
Engine
Rattle Noise Coming From the Front of the Engine
Fan clutch can make metallic clinking noises
$72.15
115 116 107 123 126 Chassis Rear End Wheel Bearing Kit
Inner and Outer Bearing and Seals for ONE SIDE ONLY (Right or Left)
$12.75
123 300TD Wagon Rear Suspension Coil Spring Shim - Maximum
Used to adjust unloaded ride height
'79 300TD oil filter housing leak
I ran a little low on coolant the other day (not sure why...), and the engine got hot (almost 200 degrees according to the gauge on the dash). after i filled the radiator, i noticed that oil had started leaking from somewhere on the engine. a can of brake cleaner revealed that the oil is leaking from under the oil filter element housing cap. so i changed the oil and filter and filter housing cap o-ring ('cause it was time for an oil change anyway), and tightened it down really tight, and it is still leaking. A LOT.
Chassis Model Number
Forums
80 300SD Fuel Filler Neck Seal
Will the Diesel Fuel Trunk Smell Fix Kit (DSL-123TSF) also fit the 116 chassis, specifically a 1980 300SD?
Chassis Model Number
Forums
300D Dies under load
1982 300D.."300D Dies under load" I have isolated fuel: changed filters, removed fuel tank and had cleaned, screen in tank cleaned,purged system with cleaner (Diesel purge), replaced fuel lines, cylinder compression across board was 305+-5,glow plugs replaced, new monark injectors (bench tested: 2300,2200,2200,2200,2150)checked timing chain and valve job (cam lobes looked good), and removed exhaust. Fuel is going to each injector. Car runs rough at idle and dies when placed into gear. In fact, while idling (high rev's motor sounds good)and I turn on air car stalls.