$529.00
1976 to 1979 450 and 6.9 Fuel Injection Delivery Overhaul Kit w/ 2 Hole Accumulator
All the parts you will need to make your 6.9 FID like new. Also fits late 450SEL (4.5) and some 1976 to 1978 450SL with 2 hole accumulators
W116
On Demand Video
$8.99
Diesel Harmonic Balancer Installation Tips and Tricks - On Demand Video
Did you forget to mark it before removal? Can't see down there to align it properly? Not sure about the bolt and washers? This video will HELP!
$21.95
40 Piece Silicone End Cap and Plug Set - Amazing Uses!
Push them over a hose and they act like a sealing end cap. Turn them around and push into a hole to act as a plug. Cut in half - use one piece for a splice between hoses.
$62.00
1978 to 1980 W116 300SD Motor and Transmission Mount Set
Old tired rubber mounts are one of the biggest causes of excessive engine vibration and shake AND noise if they are totally collapsed
$85.00
Kent's Custom Gas Engine Front Crank Seal Race Removal Tool
For most 4 cylinder, 6 cylinder and V8 engines from 1963 to 1985. Made to remove the race on the end of the crankshaft when replacing the front crank seal.
$68.75
Early 350 and 450 V8 Valve Clearance Adjusting Wrench for 17mm Ball Adjusters
The most NEGLECTED service on these early D-Jet D-Jetronic V8s. For 1969 through 1975 W111 W108 W109 R107 and W116 with the 3.5 or 4.5 V8 engine
$44.75
Cadmium Gold Plating Look-a-Like Spray Paint Kit
As seen on Kent's Youtube videos restoring old fuel delivery systems and engine parts.
$19.80
1977 to 1985 OM616 and OM617 Injection Pump Delivery Valve Reseal Washers - 10 Pack
For most engines except some euro models. Free removal tool included.
$55.00
Digital Multimeter for Testing Fuel Injection and Other Electrical Components
Auto seeking and auto adjusting. The best meter under $60 anywhere. Kent's favorite. Large easy-to-read screen. Very accurate and fast Ohm readings. Kent's training video for general electrical testing is included.
On Demand Video
$8.99
Automotive Electrical Troubleshooting Procedures 101- On Demand Video
It is not as hard as you think if you have an inexpensive volt / ohm meter and this basic knowledge from Kent Bergsma