BENZ AID - COMMON QUESTIONS AND ANSWERS

Exhaust Leak From Manifold Or Turbo on a 300SD

I noticed a bit of soot in the instrument panel of my '84 300SD. I also get a few specks of soot on the grille and under the hood. My guess is that I have a minor leak somewhere on the exhaust side of the engine. Is there anywhere that seems prone to leakage? Exhaust manifold gasket, turbo gasket, etc.? Thanks for any advice you can provide. Tim Delaney Stewiacke, NS, Canada 1984 300SD, 225,000km

Forums

Taxonomy upgrade extras

Chassis Model Number

Flex Plate location?

I recently bought an 81 300td that has a 118 transmission. When driving, there is a bad flare between 1st and second and the car "clunks" like I am dragging a can of paint under the shifter. I read (/node/49) the flex plate torque converter page and thought that may be my problem. But I can't figure out where the blasted thing is so I can check it...and if it needs replaced or needs new bolts, Kent, do you have those handy? I did just finish changing the transmission fluids and filter, oil and filter, and the inline fuel filter.

Forums

Taxonomy upgrade extras

Chassis Model Number

6.9 transmission pump

the transmission in my 6.9 has become all neutral. no engagement in any gear. this happened just after i started the car in the morning. i backed up about 3 feet, and that was it. prior to this, it worked perfectly, with no noises or malfunction of any kind. when i checked the fluid level it was very high. can anybody tell me anything? it was suggested that i check the auxiliary trans pump located below the ac compressor? help!

Forums

Taxonomy upgrade extras

Chassis Model Number

240D spun rod bearing and can't find parts!

I'm trying to find undersize rod bearings for a 1976 240D I just picked up. Seems to be pretty easy to find standards but that's it. Is it possible to return a crank journal to the standard size if the bearings aren't available? The engine was totally rebuilt a few years ago but... kid driving, hole punched in oil pan, ran out of oil and that's it.

Chassis Model Number

Forums

Diesel blow by, high oil consumption, why?

I recently purchased some of your manuals and was checking out my newly purchased 82 300td and noticed it has excessive blow by and was 3 quarts low on oil after roughly 1000mi! I did your plug the breather trick and it goes for 3-4seconds before shutting down. This car starts great on frosty mornings and has lots of power, no smoke and no oil spots on the driveway. What do you think is the best method for freeing up sticky rings? (if that's my problem) I have a friend who fills his crankcase with biodiesel after draining the oil and idles for 10min or so. Do you think this is a bad idea?

Forums

Taxonomy upgrade extras

Chassis Model Number

Electrical and wiper problems 1993 300D

I have a 1993 300D 240 turbo with a few issues I need help resolving. The windshield wiper doesn't work. I have attempted to remove the shroud below the windshield and can't or haven't gained access to the motor. Help I also have an electrical problem with the drivers headlight. I have high beam but no low. I have switched the bulbs with the passenger side and bulb is fine, fuse is fine. What's the next step? Don

Forums

Taxonomy upgrade extras

Chassis Model Number

123 Chassis Water temp sender

1985 MB 300D 123 Chassis Diesel. Dead Water temp guage looking for water temp sender ? I see three place for Senders for water temp guage #1 on the Engine block (drivers side) #2 on Water housing (passenger side) #3 On water housing (on front of engine) 1) Which sender feeds the instrument temp guage? 2) Can I check to see if the problem is guage or sender by grounding the wire goiing to the sender ? (will the needle on the guage move?)

Forums

Taxonomy upgrade extras

Chassis Model Number

Pages