With the required pressure tank you will be able to individually test and clean our D-jet fuel injectors. Along with a 12-volt power source, you will need I gallon of cleaning fluid as described in the instructions. These highly detailed video instructions will explain how to hook up the tester, perform individual injector tests, internally clean and even back flush each one, and how to interpret the results. Instructions on removing and reinstalling the injectors in your engine are NOT included, but you will find this is a very straightforward job (tips are included in the video below). In most cases, you should plan to replace the fuel hoses, seals, and internal filter screens. These parts are available separately (along with instructions). Please see our list of D-jetronic injector repair parts listed below:
Product Details
This kit is also available as a "full" kit complete with our custom-made pressure tank with a special gauge already installed ( see below ):
Tester specifications:
- 1, 2, and 3-second pulse setting
- Constant pulse setting
- Input voltage 12 volts ( via car battery or booster pack )
- Output voltage 5 volts at 3 amps (universal small injector fitting clips)
We install a resistor inline with the power cords to reduce voltage while testing your old injectors.
Related Products:
1970 to 1975 D-Jetronic V8 EFI Fuel Injector Tip and Housing Seals
These are the critical seals that go on the D-jetronic fuel injectors. If they leak air, your engine with idle high, start poorly and run lean, which can damage the pistons. We recommend you replace these whenever you remove and replace the injectors.
Bosch D-Jetronic Fuel Injector Testing and Cleaning FULL Kit
This will give you everything you will need ( except 12-volt power and cleaning fluid ) to bench clean and test your D-jetronic fuel injectors in your own garage or workshop once they are removed from the engine.
1970 to 1975 D-Jetronic V8 Engine Compartment Premium Fuel Hose Replacement Kit
These engine supply fuel hoses are critical to the well-being of your engine. I have seen too many rotten and deteriorating hoses on these D-Jet engines that could easily lead to an engine fire, and they just do not get replaced when they should.
1970 to 1975 D-Jetronic V8 Front Engine Short Hose Replacement - On Demand Video
In this 23 minute highly detailed video Kent will show you to reasons why and some of the problems you will run into when you change these hoses on your own D-Jet engine. He will take the new parts and show you how to properly install them using the correct hose clamps, sealants and lubes.
1970 to 1973 3.5 4.5 D-Jetronic V8 Points to Electronic Ignition Conversion
WARNING - WARNING - WARNING: BEFORE we ship this unit, we MUST have confirmation from you that you have removed the distributor cap, confirmed the size of your rotor ( see below), AND measured the points cam width and height. If your distributor is not exactly the same this kit WILL NOT WORK.
1970 to 1973 W108 W109 3.5 and 4.5 Fuel Pump Conversion Kit
Since new original style pumps are no longer made, this is the best way to finally fix your old fuel pump leaks and poor performance. This kit is designed specifically for the W108 and W109 small V8 sedans.
1972 to 1975 R107 350SL 450SL SLC Complete Fuel Pump Conversion Kit
Since new original style pumps are no longer made, this is the best way to finally fix your old fuel pump leaks and poor performance.