$16.50
Brake Lubricant
Stop Pad Squeal
W123, New Repair Kits Released in Past 60 Days
$8.55
Loctite Locweld Bonding Compound
Cold Weld; 2 Part Adhesive/Filler; 2-1oz Tubes
$24.95
Battery Tender (Trickle Charger) Installation Kit
NO LONGER AVAILABLE. Please see related products below for our premium upgrade of this charger kit.
$9.95
115 116 123 126 201 124 Diesel HEAVY DUTY Rubber Exhaust Hangers x 4
NEW DESIGN - Best exhaust hangers for rattle prevention - and they stay on!
1984 300D turbo differential whine highway speed
I have 1984 300D TD which has a differential whine when driven at approx 50 MPH .Noise disappears as soon as throttle released but returns when re applied. Diff has new seals, carrier bearings and appears to be in good condition.Mileage 249800mls. Car very well maintained. Any ideas????
Chassis Model Number
Forums
$12.50
Early Steering Box Adjusting Stud Replacement Locknut
Fits most models 1969 to 1995 -
$1.80
50 AMP Glow Plug Circuit Strip Fuse - Sold Individually
For 1977 to 1983 240D
1977 280e backfires through intake
My 1977 280e runs roughly. New fuel pump, fuel filter, the usual tune up. It is a little hard to start when cold or warm. It backfires out of the intake when you step on the throttle. I have disconnected the intake vacuum line and plugged it that leads to the cabin. The EGR valve has been plugged off as well. Most places I have read always say the backfire issue is almost always vacuum related in this car.I've checked all of the rubber vacuum connectors and they seem to be good and snug fitting.THe car idles at around 550 RPMs.
Chassis Model Number
Forums
injection pump oil level on 79 240D
Does anyone know if you need to check/adjust oil level in the injector pump after an in service primer fuel pump change? I know the factory manual says to fill it when you put on a new injection pump.
Thanks
Mike
Chassis Model Number
Forums
Difference between turbo issues, ALDA issues and wastgate
I have a 1985 Turbo federal model...no particulate filter. I bought the turbo rebuild kit and tested the turbo beforehand. It only boosts to 7.5 psi without the installation of the kit (in summeer). I have not rebuilt the turbo yet. The car is extremely slow off the line and in cold weather....I can floor it for three minutes with no increase in RPM. (Some people even cut my block heater cord off because it smoked so much....as if that would stop me!)