$4.20
615 616 617 Diesel Engine Vacuum Pump Housing Bolts and Washers x 6
Fits diesel vacuum pumps 1969 to 1985 220D 240D 300D 300CD 300TD 300SD
W123, Electrical
$59.80
1980 to 1985 123 Bolt Type Axle Boot Replacement Kit - NO INSTRUCTIONS
For bolt together axles only on 240D 300D 300CD and 300TD to 1985 - see details below
Body and Exterior Trim
Removing Glued on 123 Chassis Front Fenders
Tough job and you will need heat! Also applies to 107, 114, 115, and 116 chassis
'79 300TD Lift Gate Strut(s) Replacement
I'm assuming that in order to replace lift gate struts, the molded plastic headliner piece must be removed. I have re-
moved the six small screws and the rear interior overhead light fixture but the headliner piece remains firmly
attached. What don't I know now? Thanks in advance for your help.
Chassis Model Number
Forums
1983 300D electronic speedometer conversion?
I replaced a failing differential in a 1983 300D which had a 3.07/1 final drive ratio with a w126 differential with a 2.47/1 final drive ratio. RUNS GREAT!!! Of course, what the tranny-driven mechanical speedometer-odometer now registers is about 80% of what the actual speed and mileage are. I would like the instruments to reflect actual speed and mileage.
In the original vehicle, an electrical speed sensing unit on the differential connects to the instrument cluster.
Chassis Model Number
Forums
1985 300D center flap actuator removal
I believe that the vacuum actuator for the center flaps needs replacement. Unfortunately, it looks like it's a real difficult part to remove. I'm wondering if you've ever had to pull and replace this? If yes, how did you do it? And ::fingers crossed:: were you able to do it without removing the dash?
Chassis Model Number
Forums
1985 3000TD Bypass the Coolant Heat Exchanger?
When running diesel fuel should the coolant heat exchanger be by-passed with valving so the diesel fuel is not heated? My current setup heats fuel to 140 - 150F at the IP when looped mode is not used.
Chassis Model Number
Forums
1984 300TD A/C not blowing cold
I have a '84 300TD wagon. Last year I took the car in to get the A/C checked out as it was not working when I purchased the car. They checked the lines and it seemed to hold pressure just fine. They replaced the valve with one for R134 and put two cans in, and at once the compressor kicked on and started blowing cold air. The aux fan has never worked but that didn't seem to matter much unless I was standing still and it would be a little less cool. Everything has been working fine for the last year, until recently.
Chassis Model Number
Forums
$22.00
616 617 Diesel Engine Harmonic Balancer Puller
Works on 1969 to 1985 Diesels 220D 240D 300D 300CD 300TD and 300SD - Also works on older 6 cylinder gas engines to 1972
performing diesel purge with wvo kit installed.
Was wondering how to perform diesel purge on my car which has a wvo system installed by greasecar. I can't seem to determine which is the incoming diesel line.
Any help would be well appreciated.
Thanks