W116, Body and Interior Specific Aid
Side Trim Molding Clips - set of (10)
alloy wheel rim color-1983 300sd
n/a What color paint was used on the alloy rims on the 1983 300sd.
Chassis Model Number
Forums
1977 W123 dash lights not working
My dash/center IP lights don't work. I already tried replacing the dimmer switch and that didn't help. I replaced the headlight switch when I first got the car so it might have something to do with that since the replacement one was not exactly like the one I replaced. I've also checked all the fuses in the fuse box and replaced the bulbs with ones that were tested. All the warning/turn signal lights work, just not the ones that light up the dash/trans/etc.
Chassis Model Number
Forums
how to remove outer door handle 1984 300SD
Drivers door lock will not turn either direction. Pulled door panel can see single wire to handle assembly broken. How do I get handle loose from latch assembly? Afraid to break the rod. What is the trick??Need to pull handle out from door to access and repair the wire.
Chassis Model Number
Forums
1986 560 SEL Burl Wood Ttrim
The burl wood trim on the dash and doors of my "86 560 SEL needs help, but I have not found a source to help with repair or replacement except the dealer which runs over $3500. Any ides's? john
Chassis Model Number
Forums
Rocker Panel and Floor Permanent Rust Repair without Welding
1982 240D ignition switch faliure?
After turning off the car and removing the key the radio remains on and the aux fuel boost pump wired to activate in the aux mode continues to pressurize the fuel system. Car has 232K and in the last 19 years of ownership I have not replaced the ignition switch.
Is my diagnosis accurate of a failed ignition switch in the acc. position?
Chassis Model Number
Forums
Early 123 Early 107 Late 116 Genuine OEM Ignition Switch
1985 300SD Turbodiesel shoulder strap retractor
n/a Passenger side shoulder strap retractor does not work. Can it be fixed?If so, how is removal of trim piece to access components accomplished? The belt has been completely extended and will not return. Does it work with some sort of spring device?
Thanks for any suggestions,
Judd