Loud Noise/Vibration when turning - 1979 300SD ??
loudish noise when turning on my 1979 300SD at any speed.
seems to be coming from the drivers side front wheel.
newish tires and alignment. front end work done within the last 6 months.
Thoughts?
W116, Body and Interior Specific Aid
123 Wagon Sunroof Parts
I am rebulding a sunroof from a 1984 wagon and need to know about availability of the white plastic glides/guides for the rear of the sunroof. They clip onto a bracket at each rear corner of the sunroof. Alternatively, can I use the felt glides that fit the front corners?
thanks for your help!
Chassis Model Number
Forums
$675.00
1977 to 1981 ACC II Climate Control Servo Replacement - Modern Electronic Upgrade
Written instructions are included. Extra on-demand videos to help you understand the ORIGINAL are included at no extra charge ($25 value).
Engine
Problems You Might Encounter Running Biodiesel
Biodiesel is not too kind to rubber
1971, 280SE 3.5 Coupe, Interior Wood Trim Removal
How to remove the interior wood trim under the windshield (on the dash)?
1. Is it clipped? How do the clips look like?
2. Do I destroy them during removal and need new ones?
3. Are special tools needed? I have a set of plastic tools, which I used for removing the aluminum trim outside.
4. Is the method the same for all MB's between 1962 - 1972, which had these trims (108,109,110,111,112)?
Thanks
Chassis Model Number
Forums
$4.20
615 616 617 Diesel Engine Vacuum Pump Housing Bolts and Washers x 6
Fits diesel vacuum pumps 1969 to 1985 220D 240D 300D 300CD 300TD 300SD
Rear window regulator
Trying to replace the regulator slide on a 83' 126. I have everything off and the regulator is unbolted and loose, but I can't seem to fiqure out how to disconnect the wireing. It seems to be hard wired into the regulator and unhooking the switch still leaves wires connected. Please help, before I start splicing.
Thanks again for the help!!!!
Chassis Model Number
Forums
Body and Exterior Trim
Removing Glued on 123 Chassis Front Fenders
Tough job and you will need heat! Also applies to 107, 114, 115, and 116 chassis
'79 300TD Lift Gate Strut(s) Replacement
I'm assuming that in order to replace lift gate struts, the molded plastic headliner piece must be removed. I have re-
moved the six small screws and the rear interior overhead light fixture but the headliner piece remains firmly
attached. What don't I know now? Thanks in advance for your help.
Chassis Model Number
Forums
1983 300D electronic speedometer conversion?
I replaced a failing differential in a 1983 300D which had a 3.07/1 final drive ratio with a w126 differential with a 2.47/1 final drive ratio. RUNS GREAT!!! Of course, what the tranny-driven mechanical speedometer-odometer now registers is about 80% of what the actual speed and mileage are. I would like the instruments to reflect actual speed and mileage.
In the original vehicle, an electrical speed sensing unit on the differential connects to the instrument cluster.