$85.00
617 5 Cylinder Turbo Diesel Cylinder Head Bolt Set- USED
Replace when heads have been damaged, bolts are severely rusty, or the engine has been overheated
W116
Kick down for transmission
My 1979 300SD Turbo has a rebuild transmission, a new kick down switch and still will not downshift. Any suggestions??? Fusebox has been checked, and linkage adjusted.
What is the approximate cost for a valve adjustment on the above model car??
Forums
Taxonomy upgrade extras
Chassis Model Number
Grinding Brakes
Hello,
I just did a complete brake job on my 1979 300SD. Replaced all the rotors, calipers, and brake pads, as well as the master cylinder.
It all went fine, except now when I turn, there is a grinding noise that comes from the front wheels, it's like the brakes are grinding, but it only happens when I'm not driving straight.
Any Suggestions?
Thanks,
Jeff
Forums
Taxonomy upgrade extras
Chassis Model Number
$3.75
1970s and 1980s Black Plastic Interior Door Lock Knob- USED
Fits 116 114 115 123 126 and 201 chassis
450se hydraulic lifters
the left hand bank hydraulic lifters are not working.
this happened while the engine was ticking over at 800rpm.
the revs dropped off gradually until the engine syopped.
all the lifters do not rise even though the oil pressure while cranking the engine is good.
i am using the "left hand" term as stated in the manual,it is actually the right hand bank when view from the front of the vehicle.
any ideas?
Forums
Taxonomy upgrade extras
Chassis Model Number
$22.00
616, 617 Diesel Engine Crank Front Bolt Washers Seet of 3 - USED
1977 to 1985 240D 300D 300CD 300TD 300SD
Fuse constantly blowing
Hello,
I've got a 1979 300SD which has an electrical problem. The fuse that runs the brake lights, turn signals, and fuel gauge keeps blowing. I looked in the trunk at the brake lights and unhooked a trailer brake light harness, because I thought that might be it...but it was not.
Any suggestions?
thanks,
Jeff
Forums
Taxonomy upgrade extras
Chassis Model Number
turbo oil line gasket and air cleaner bracket
I recently replaced my air cleaner bracket which required disconnecting and reconnecting the oil line from the top of the turbo. After reassembling everything, the turbocharger leaked oil. There's a paper gasket where the oil line meets the turbo, and I didn't know I'd have to replace it if I ever disconnect the oil line. I got a new one from a local M-B dealer, partnumber A 603 187 05 80, but it's the wrong size. I tried to use the gasket anyway by making cuts in the gasket, but I doubt it is sealed well or will last very long.
Chassis Model Number
Forums
$43.95
116 123 126 Chassis Fuel Tank Outlet Screen Removal Socket
WORKS ON FUEL TANK SENDING UNITS TOO! Machined short for easier access and a sharper edge for better grip.
