$295.00
OM 617 Turbo Diesel Front Crank Balancer with Bolts and Pulleys
LAST ONE! Be forwarned - if your center crank bolt loosens up these parts will come loose - and disappear along the road!
W116
$17.50
116 123 126 Chassis Front Outer Wheel Bearing
240D 300CD 300D 300SD 300TD
Problem with w116 280S carburetor
I own a 1976 W116 280S that used to run perfectly well but now problem is with its carburetor. Sometimes the float chamber has to be adjusted in order to run the engine and this is happening so frequently that I need a lasting solution to the problem. Otherwise at the rate which am experiencing the problem, I might get stuck right in the middle of nowhere.
Forums
Taxonomy upgrade extras
Chassis Model Number
$40.00
14 Inch Standard Factory Hubcap - 1968 to 1985 - NOT Painted- USED
Very nice outer edge - Stainless steel - 4 clips included
$85.00
617 5 Cylinder Turbo Diesel Cylinder Head Bolt Set- USED
Replace when heads have been damaged, bolts are severely rusty, or the engine has been overheated
Kick down for transmission
My 1979 300SD Turbo has a rebuild transmission, a new kick down switch and still will not downshift. Any suggestions??? Fusebox has been checked, and linkage adjusted.
What is the approximate cost for a valve adjustment on the above model car??
Forums
Taxonomy upgrade extras
Chassis Model Number
Grinding Brakes
Hello,
I just did a complete brake job on my 1979 300SD. Replaced all the rotors, calipers, and brake pads, as well as the master cylinder.
It all went fine, except now when I turn, there is a grinding noise that comes from the front wheels, it's like the brakes are grinding, but it only happens when I'm not driving straight.
Any Suggestions?
Thanks,
Jeff
Forums
Taxonomy upgrade extras
Chassis Model Number
$3.75
1970s and 1980s Black Plastic Interior Door Lock Knob- USED
Fits 116 114 115 123 126 and 201 chassis
450se hydraulic lifters
the left hand bank hydraulic lifters are not working.
this happened while the engine was ticking over at 800rpm.
the revs dropped off gradually until the engine syopped.
all the lifters do not rise even though the oil pressure while cranking the engine is good.
i am using the "left hand" term as stated in the manual,it is actually the right hand bank when view from the front of the vehicle.
any ideas?