CHECK OUT our new parts and kits for 2007 to 2012 models CLICK HERE to view all.
n/a After installing the new oil tube fittings, I started to remove the cam gear so that I could change the chain guide. After I had the gear about half way off, the chain was so tight that I stopped, fearing that I would not be able to reinstall it. Is there a trick to loosen the chain. I have been going by Kent's manual.
Has anyone got a easy way to change injector pump on 1984 300SD. The rack sensor is just above the back bolt and makes putting the nut bavk on interesting. The gasket started leaking because the support at the back of the pump was not bolted to engine.
I was told by a mechanic that ceramic brake pads would not stop or wear as well on my 85 300TD. Is this true? Why?
Is there a particular type of hose that must be used for the Turbo Connector Hose?
My turbo had a braided hose, similar to that of the fuel line return hoses but larger, that was leaking pretty badly at both ends. I removed it and took it into my local parts store and the guy at the counter said that I needed that particular style hose. He cut me a length of 3/8" fuel hose to hold me over until I could get my hands on some.
my 1988 190d does not blow out heat on the feet.What could be the problem?my 1984 300d also has same problem no heat blowing out on floor.Vacuum problem?
I've replaced the glow plugs, strap fuse, glow plug relay and the ignition switch on my 79 300D. Intermittently, she doesn't start in PARK ( glow plug indicator light goes on , but doesn't start when the key is turned)-- If I shift to NEUTRAL, she starts fine. I pay attention to the warnings this" Panzerwagen" gives me , so I'm thinking that there's some glitch in the neutral safety switch.
Am I on the right track? Please excuse potentially incorrect terminology- I'm no expert, which id why I subscribe to this helpful forum.
Thanks in advance for your help.
I know there is a remedy for this..but I can't find it on here again. My 84 300D starts right up cold, no problem. But after I turn it off and try to restart..the engine just turns over without starting unless I turn the key off then immediately turn the key on again..starts right up...anyone know the answer..? Thanks for any help !!
Will the tach from a 420SEL work in a 1983 SD? Because I have the rear axle of a 420 in my 83 300SD I am using the speedometer from the 420 for accurate reading already. The original tach and clock are not working I know that the plug in is different, but are there any other issues to consider?
Hi have a question about an 1984 300D. HVAC fan comes on when your first turn the key to run, then after starting the car it shuts off and wont come on again ever. If you click the key back just a little it comes on. What do you think?
Can the flex discs be replaced without removing the drive shaft? Do you sell the discs with instructions to fit this car?