123 300TD Wagon SLS to standard shock conversion ??
I am considering changing my 85 wagon from sls to spring and shock. What springs and shocks do I need to order? Are there any other recommendations you might have ? Thank you.
W126, BENZ AID - COMMON QUESTIONS AND ANSWERS
79 W123 300D-Blown Radiator?
Driving down the interstate on my way to a gig (I'm a musician)- First noted the BATT light come on-Which I assumed correctly to be a shot belt- but also noted the engine was overheating.This is a new (3yrs old) OEM BEHR radiator I installed) Pulled over-antifreeze all over, radiator cap intact,but the top of the radiator was tilted about 20 degrees from horizontal, tilting up at the engine side, exposing the rubber tubular gasket around the top, and the metal mesh underneath. Obviously bent up somehow and in doing so disconnected the plastic housing.
Chassis Model Number
Forums
380SL - hard top trim removel
n/a How do you remove the two top trim strips on the hard top. Do they snap out, or are they attatched from below.
Chassis Model Number
Forums
Vacuum
603 Diesel Engine Vacuum Hose Leaks and Faulty Routing
If the hoses are leaking or are not hooked up properly a number of problems could occur.
1985 Mercedes 300TD Injection Pump Replacement?
My injection pump is failing. How do I purchase a used IP and be sure it will fit my engine? What, if any, part numbers are necessary to insure a proper match? And, where are the part numbers located on the IP?
Chassis Model Number
Forums
$149.95
6 cylinder 603 engine Auxiliary Fan
Fits 1987 300D and 300TD / 1986 and 1987 300SDL --- Also fits 1985 YEAR 300SD ONLY
'76 300D No start
Have the glow relay manual override installed. Last week I pressed the button, got glow for a few seconds, then a fast clicking. Was able to start the car. Now I get fast clicking & no start.
Battery tests fine. Tried powering the starter directly by jumping to the solenoid but I only get a click.
Not sure how to troubleshoot from here. Any tips would be appreciated!
Thanks,
Nicole
Chassis Model Number
Forums
82 300TD Engine Heater
Making my question simpler. I am removing the engine plug to install the block heater. I am using a 19mm 1/2 inch drive Allen an extension and a 20 inch breaker bar. I have put some torque on it and it does not budge. I do not want to break anything. How much torque is safe? Any suggestions?
Thank you
Chassis Model Number
Forums
Body and Exterior Trim
Finding your Mercedes Factory Paint Color Code
This can sometimes be a real challenge if you do not know where to look
Interior
Drooping or Floppy Sun Visors
There is a simple fix to keep those old sun visors up