$149.95
6 cylinder 603 engine Auxiliary Fan
Fits 1987 300D and 300TD / 1986 and 1987 300SDL --- Also fits 1985 YEAR 300SD ONLY
W126, BENZ AID - COMMON QUESTIONS AND ANSWERS
'76 300D No start
Have the glow relay manual override installed. Last week I pressed the button, got glow for a few seconds, then a fast clicking. Was able to start the car. Now I get fast clicking & no start.
Battery tests fine. Tried powering the starter directly by jumping to the solenoid but I only get a click.
Not sure how to troubleshoot from here. Any tips would be appreciated!
Thanks,
Nicole
Chassis Model Number
Forums
82 300TD Engine Heater
Making my question simpler. I am removing the engine plug to install the block heater. I am using a 19mm 1/2 inch drive Allen an extension and a 20 inch breaker bar. I have put some torque on it and it does not budge. I do not want to break anything. How much torque is safe? Any suggestions?
Thank you
Chassis Model Number
Forums
Body and Exterior Trim
Finding your Mercedes Factory Paint Color Code
This can sometimes be a real challenge if you do not know where to look
Interior
Drooping or Floppy Sun Visors
There is a simple fix to keep those old sun visors up
Injection Pump Shutoff Valve Malfunction
I am having problems with my Injection Pump Shutoff Valve...when I first start the car up the Valve is in the upright position..when I shut the car off it stops down and shuts the engine off. Then when I come back to restart the car a few minutes later..and turn the key to start..the engine turns over but will not start because the Shutoff Valve is down, but when I immediately turn the key off then back on, it comes up and starts the car immediately.
Chassis Model Number
Forums
85 300TD Clock Knob Broke Off how to fix?
I dropped my car off at an auto body shop for a minor repair.
When I picked up the car I noticed the knob that adjusts the clock was mysteriously broken off. I found the knob, but it does not look like it can be glued back on.
Do I have to replace the entire cluster? Can the knob be replaced from behind the cluster?
G
Chassis Model Number
Forums
84 280E W123 Leaking steering box ??
The steering box on my 280E is leaking fluid. It appears to be from the seal near where the pitman arm attaches to the output shaft. My local Mercedes specialist tells me that this is a time consuming and expensive repair involving a strip down and replacement of the (many) seals within the box. Although I intend to get this done in the next few months, is it worthwhile in the interim flushing the system and adding a power-steering stop leak product to the new fluid, or is this just a waste of time?
Chassis Model Number
Forums
1978 300SD sway bar bushing location ??
Hello,
I'm getting a clunking noise in the front end when I go over bumps. I poked around underneath and couldn't find any play or wear anywhere, so I took it to a local shop. The mech said I've got a bad sway bar bushing, and it's "impossible" to get at. He also said it's not worth fixing since it's not dangerous as is. Is he right? Anyone else have a similar problem with this bushing? I'm considering going to another shop for a second opinion, since this could be a safety issue.
Thanks!
Chassis Model Number
Forums
Oil in Aircleaner housing '82 300sd
Hi Kent, why would I have oil in the bottom of my air cleaner housing after air filter is removed? The circuit is simple, blowby travels up and out VC into oil separator which then flows back down drain tube to sump. I have poured fresh oil down tube and it definitely drains -this one has me stumped! Thank you!
James Soule
1982 300SD