1988 560SL M/B 02 sensor
When reading across the two contacts on the 02 sensor with an ohm meter, should the reading show open or close contacts.(trying to determine if te sensor is shorted or not) please help. Thanks
CHECK OUT our new parts and kits for 2007 to 2012 models CLICK HERE to view all.
When reading across the two contacts on the 02 sensor with an ohm meter, should the reading show open or close contacts.(trying to determine if te sensor is shorted or not) please help. Thanks
diy ball joint replacement - 1985 300td Sedan
Currently squeeks like an old couch! Just embracing the diy arena after the local mechanic quoted 3.1 hours labor for each joint (it it true???) Have ordered replacement ball joints. Any helpful hints or how to is appreciated - have searched the site. Your input is valuable - is this doable for the novice, novice, first timer?
I have purchased new weather-stripping from my Mercedes dealer for my 1974 240D 115. I removed the old weather-stripping on the front passenger door and tried to install. After carefully pushing the new weather-stripping in the door channels. The weather-stripping didn’t quite fit. About 3” to long. Is there any way to “shrink” the weather-stripping before the install? Or should I just return and order another. Any tips would be helpful.
Thanks,
Eric
Is it possible and/or practical to swap my passenger seat with my drivers seat? I have a very good passenger seat and a poor drivers seat.
103 engine. Rough idle at cold start up. Smooths out after 30-45 seconds.
When starting warm, starts right away and stalls immediately – re starts right away OK and stays running. Recently hesitates when cold. Been unusually cold her in FL lately. Any thoughts??
Any tips or "how to" on how to reattach the front rubber bumper?
Hi,
I am again successfully confused by the website, so need to be unconfused once more:
On your website under the item "Heavy Duty Monark Ultimate Hand Primer Pump" I have read the following sentence: <...works great with SVO WVO fuels> therefore I bought the pump.
Then once I received it, the instruction booklet that came with it said: <...Its only disadvantage, it will not work well with bio-diesel and it may not work at all with waste vegetable oil SVO/WVO...>> but the problem, that is what I want to use with eventually.
Hello
It's been nearly a year since I sold my last Mercedes (1981 240D - my fourth diesel Benz since 1996) to pay for my honeymoon.
Anywho, it's project time again, and I'm picking up a 1971 220D this weekend that will need a LOT of love. It's a southern car that has been up here in the northeast for about ten years (only driven here the first five). It's got rust (looks fixable to me so far) and is definitely a long term project, but I couldn't pass up a running 4-speed manual W115 diesel at the price.
For no reason at all I have no throttle response it will get up to about 1000 RPM and hit a wall. It wasn't like that yesterday. I have new injector nozzels balanced clean hard lines new filters (pre-filter is the aluminum filter I got here) diesel purged. the only thing I did was install a trans vac.
n/a
Can someone give me some info on what a reasonable cost would be to replace the leaking rear seal on the transmission of this car. I understand that the tranny must be removed so it is not something I can tackle myself. Plus, there are specialized tools etc. required to do the job correctly.