1982 stored 10 years hard to start
I'm trying to get a 300 d started that has been in storage in a garage for 10 years. It will crank but will not hit. I have replaced both fuel filters and primed it to the injectors. Still not starting. Any ideas?
W123, Electrical
1979 300D start problem
1979 300D. Stored for 4 years won't start without the block heater when it is below 60 degrees. The oil was not changed during storage. Glow plugs appear to cycle. Does anybody have any ideas? I am looking at purchasing this car but want to avoid a big engine problem.
Thanks!
Chassis Model Number
Forums
how to turn idle up on 83,coupe diesel
I Have an 1983 123,Mercedes Benz Coupe diesel and Would like to know How to turn the idle up 900RPM. Any help advise would be helpful.e-mail Brubaker72@gmail.com
Chassis Model Number
Forums
wagon rear end keeps bouncing (bad shocks)?
I recently purchased an 82 300 td. When I am driving the rear end bounces up and down. it has fluid in the reservoir.
Thanks
Chassis Model Number
Forums
$4.95
Transmission Shift Rod Retaining Clip X 2
Fits late 108 113 111 109 and 107 116 114 115 123 126 201 and 124 Chassis
A/C problem with my 1984 300DT
On rare occasions when I turn the A/C on and select high fan speed the blower is very fast (read powerful) and the temperature is very cold......Great! On other occasions in fact most of the time when the A/C temp is selected and the high speed fan switch is selected the fan is slow and the temperature is warm to cool. Yet at other times if I switch off the engine before switching off the A/C for example when refueling and then turn the engine back on the fan blows H-O-T.
Chassis Model Number
Forums
fuel leak related to power loss?
I have been experiencing an occassional power loss for quite some time now. A while back i took care of this problem when i found a loose clamp on the hose going to the hand primer pump. After tightening it and bleeding the system it took care of the problem.
Now i have a small fluid leak that i believe is coming from the bottom of the clear sediment bowl on my FM100. It is too difficult to tighten in its current position, so i have been putting off removing the FM100 filter.
Anyway, my question is this, can a small fuel leak like that be responsible for power loss?
Chassis Model Number
Forums
Mono valve question on 1982 300TD
Hello,
My Monovalve, the one that is bolted to the firewall and allows coolant into the heater core, has been stuck wide open, I removed it and it seems to be able to move now that I have cleaned it up a bit, is this item repairable, or should I just buy a new one....
Thanks
Chassis Model Number
Forums
1985 300sd 30 mph max no power
I just purchased this car. It starts quickly and idles smoothly but has no power and will only go about 30 on flat ground. I removed exhaust pipe with the cat and muffler, thinking the cat was plugged, didnt help. the previous owner said the turbo got hot and caught the underhood insulation on fire but he got it out quickly and with the exception of 2 vacumn lines it didnt hurt anything. turbo area emits a highpressure air sound, not a turbo whistle,at idle and it gets louder under power. Any suggestions? Thanks Tom Postscript 1st benz Ive owned so have to catch up.