$58.00
W123 Chassis Sedan and Wagon Driver Side Front Door Seal
Fits Later 240D 300D 300TD 280E 1980 to 1985 LEFT Front - Stop the wind noise!
R107, New Parts Kits and Manuals
$39.60
High Visibility Easy Adjust Click-Stop 3/8 Inch Drive Torque Wrench and Case
Perfect size for torquing spark plugs and other under 50 ft. lbs. important engine components.
Suspension
Loose and Rattling Exhaust System
Failure to replace the donuts could leave your exhaust dragging on the ground!
$3.99
Maintenance-Handy Pick Tool Set
Small enough to get into tight places - i.e. brake clips and heat shields
Engine
Rotating Your Engine During Service and Maintenance
Best done from the front crankshaft bolt
$31.80
Engine Crank Rotation Adjustable Length 1/2 Inch Drive Ratchet Wrench
Rotate Engines on 220D 240D 300D 300CD 300TD 300SD 300SDL and all V8's from 1970 to 1991 - Extends to 18 inches long!
$16.75
Axle Shaft Seal
$2.75
Service 10 mm Head Size Locking Nuts ( Set of 10 )
Common size on all Mercedes
$45.80
Early Diesel Pre Chamber Removal Threaded Tool (up through 1987 models only)
A slide hammer is required. A collar nut tool is required. See the full explanation below
1980 450 SLC Engine Stalling after long run
Hi Folks ,
I recently bought a 450SLC in reasonable condition with a view to restoring.Motor starts fine & goes well.
I took it for a long run a couple of weeks a go & covered about 150kms without incident until I came back to town & stopped at traffic lights. The car started jerking when I took off & started loosing power. I managed to get home with problem slowly getting worse.
I turned the engine off & restarted it a few minutes later & it seemed to be revving cleanly again , but didn't take it out again until a couple of weeks later.