$12.75
Very High Temp Engine Sealing Compound
Elring Dirko brand Permanently Elastic; 85g Tube - Rated to 600 F
W110 W111 W112 Sedan, BENZ AID - COMMON QUESTIONS AND ANSWERS
$16.50
Brake Lubricant
Stop Pad Squeal
$8.55
Loctite Locweld Bonding Compound
Cold Weld; 2 Part Adhesive/Filler; 2-1oz Tubes
$24.95
Battery Tender (Trickle Charger) Installation Kit
NO LONGER AVAILABLE. Please see related products below for our premium upgrade of this charger kit.
$9.95
115 116 123 126 201 124 Diesel HEAVY DUTY Rubber Exhaust Hangers x 4
NEW DESIGN - Best exhaust hangers for rattle prevention - and they stay on!
85-300SD Battery Drains Dead Nightly?
I am baffled finding direction for a solution with problem. Every morning I need a jump start. I have a new Bosch battery purchased 30 days ago. Once charged it runs for the day. However, when I start the car throughout the day the driver front seat starts to move forward until the car slowly fires backup? This is recent situation and I have not made any significant changes to the 300SD that would affect this situation.
Need troubleshooting advice. Thanks for any guidance.
Chassis Model Number
Forums
84 300SD weak ignition switch
I have an 84 300 SD with 279,000 miles. My wife has a key ring on the ignition key. After 28 years the weight has caused the ignition switch return spring to weaken to the point with just the key in the ignition alone it won't return to the II spot. My question is, is that spring that returns the switch to the run position in the key part of the lock itself or the is it part of the larger locking mechanism?
Chassis Model Number
Forums
1984 300D turbo differential whine highway speed
I have 1984 300D TD which has a differential whine when driven at approx 50 MPH .Noise disappears as soon as throttle released but returns when re applied. Diff has new seals, carrier bearings and appears to be in good condition.Mileage 249800mls. Car very well maintained. Any ideas????
Chassis Model Number
Forums
1986 300SDL hood spring?
I was driving down the street and my hood came unlatched and bent backward over the windshield. (I don't think I had it latched completely down.) I was able to stop and bend it back down, but the hood is dented and the driver's side (large) hood spring came loose.
How do I replace the spring? I am going to replace the hood (but have not yet.) will it be easier to do with the hood off? I barely get my hand down next to the fuse box say nothing of figure out how to stretch that spring into place. Is there a special tool for this job?
Thanks
Scott