85 300TD cruise control inop
The cruise control on my 85 300TD used to work intemittently, but has not worked at all for a few months. What are the common problems which cause it not to work?
BENZ AID - COMMON QUESTIONS AND ANSWERS
1980 300D Starter Removal
I'm having a heck of a time breaking loose the two bolts that hold the starter to the engine block (i.e., the two bolts that require an Allen wrench). They're in a very awkward place (especially the top one), and I don't have enough clearance to use a cheater bar. Any recommendations on how I can get them out?
Thanks!
Collin
Chassis Model Number
Forums
86 300SDL upgraded alternator installation
I purchased a higher output alternator for my 300sdl however it doesn't have a voltage regulator in it. My stock alternator has an internal voltage regulator. What do i do? Can I install a external one? What specs do i need to know? Where can i get one? thanks
Chassis Model Number
Forums
616 617 Diesel Engine Oil Flush?
I have changed the oil on a diesel 123 for a friend and after pouring in the new oil I checked the stick and it was instantly black! Is there a remedy? Perhaps a detergent to flush engine?
Chassis Model Number
Forums
A/C turns to heat on downshift '82 300CDT
This question has been driving me crazy since this summer.
The A/C on my car works fine until I am forced to slow down or come to a stop, when this happens the A/C quits blowing cold and starts blowing extremely hot air, hotter than the highest heater function. My theory is that the phenomena happens in conjunction with a downshift in the transmission but beyond that I don't know what to do. The dealer wanted to start throwing parts at it but that can be very expensive without knowing. The compressor seems to be ok.
Help would be appreciated.
mdeming
Chassis Model Number
Forums
Plastic radiator neck kit- Well worth it!
For a couple of years I've seen your notice about the weak Behr radiator neck and the suggestion to fix it with your repair kit. But it would never happen to me, right?
Last week I found what I thought was a loose clamp on the neck of the radiator. When tightening the screw the hose came off in my hand taking off the first inch or so of the neck with it! Digging out the small end the neck from the inside of the hose I ordered the repair kit from you and made a very successful repair.
Thanks for coming up with that kit-you saved me mucho bucks and aggravation I don't need.
Chassis Model Number
Forums
97 E320 gas 104 has rhythmic vibration
I get a mild rhythmic vibration felt mostly in the steering wheel starting around 40 mph and up. I am thinking its coming from the driveshift maybe it has a little up and down play in the hanger bearing does this make sense? or should I be looking some where else.
Forums
1985 300D water leak
Despite replacing the windshield and rear window seals, the door window seals and the sunroof seals, water still puddles on the floor of the front passenger compartment. I have looked at the drains under the hood hinges. They seem to be clogged but I can't get a wire very far into them and it seems impossible to blow them out with compressed air. Where do they exit? Can one clean them from the underside? The repair manual on CD I got from Mercedes is no help. A lot of the information (visuals)on that CD is very bad quality. Where else should I look for possible water entrance points?
Chassis Model Number
Forums
1980 300D Difficulty Starting - Spinning Sound
Hi, all.
Three times that I attempted to start my car today, the engine didn't turn over right away, and I heard a spinning sound. Would it be safe to assume this is either the solenoid or the enitre starter motor?
Thanks!
Collin
Chassis Model Number
Forums
1982 300D rough, low idle during warmup only
My problem has been coming on slowly, it seems whenever starting the car hot or cold i have to depress the accelerator pedal once before turning the key and it will start no problem, use to not have to do that. now that it is getting colder outside after doing this procedure on the first start of the day the engine seems to have a low rough idle and sometimes have to hold the accelerator with slight pressure to keep the car from stalling, also some of the time the idle will slowly surge a few times, once the coolant temp gauge starts to rise the problem will go away.