Transmission
Preventing Transmission Oil Pan Leaks
Be Kind to Your Transmission Pan Gasket!
W126, BENZ AID - COMMON QUESTIONS AND ANSWERS
$19.75
LEFT HAND Thread Front Steering Tie Rod End
For Chassis 110 111 112 113 108 109 107 114 115 116 123 126 Models Listed Below 1963 to 1991
$19.85
RIGHT HAND Thread Front Steering Tie Rod End
For Chassis 110 111 112 113 108 109 107 114 115 116 123 126 Models Listed Below 1963 to 1991
$38.50
123 Turbo Diesel and Some 126 Diesel and Gas Engine Motor Mounts - Set of 2
ALSO FITS 116 300SD --- Fits only those models listed below from 1978 to 1991
$24.95
Late 126 and 201 124 Chassis Auto Transmission Mount
Fits above chassis models listed below from 1986 to 1995 except 300D 2.5
85 300SD w/ Trap Oxidizer vacuum presure reading
I followed Kent's instructions the best I could in his Vacuum Diagnostic manual. Here is what I did and what readings I got: following the main black plastic line to the firewall, there are several lines that split off. 5 in total, I believe. I unplugged the four smaller, colored lines and plugged them with golf tees. The remaining line is actually some sort of plastic housing unit with a curved rubber hose attached. I took my measurements from this point and with the engine on, I got a measurement of 10 psi from my mityvac. I think this means something is up with my vacuum pump, unless I performed my measurements incorrectly.
Chassis Model Number
Forums
$39.50
123 126 201 107 Hazard Flasher switch
VERY LIMITED INVENTORY!! All above chassis Gasoline and Diesel from 1982 to 1991
Idle problems for '82 300 TD
I have an idle problem that will rise and then drop to a lower RPM when cold. After the engine warms up, the problem is gone. What could be the most likely cause?
Chassis Model Number
Forums
1975 300D Engine Clean to remove Diesel
What's a good process to remove diesel fuel and oil from the engine and engine parts including rubber parts like rubber mounts.
Chassis Model Number
Forums
1989 420SEL Front ABS sensor removal
Is there a trick to removing the front ABS sensors for cleaning other than removing the single bolt? The sensors do not readily come out and I don't want to apply pressure and break them.