W116, BENZ AID - COMMON QUESTIONS AND ANSWERS
1982 300SD W-126 injection timing
I/P timing seems to wonder when checking. Car ran fine but in the quest to make sure my timing is set to 24 BTDC I noticed that it was moving around. I thought timing chain stretch so bought the kit, installed and I/P timing still moves from between BTDC to ATDC. I'm not able to get it even close to the correct timing spot. Help!!
Chassis Model Number
Forums
1975 300D Fuel Reserve Light Not Working
My fuel reserve light did not come on with 1 gallon of fuel remaining in the tank. Is this a DIY job? Thanks.
Chassis Model Number
Forums
83 300D Low MPG
MPG
Finally got a chance to make an extended highway trip on my new (for me) '83 300D. This is a one-owner car with a verified 116k miles. Drove 323 miles on I-75 on cruise control for 80% of the time at 2800 rpm for an indicated 65 mph. I drove about 30 miles on city streets and the rest on cruise control at 3,000 rpm. My mpg was 24.33. The mpg seems low. EPA says 30. I wonder if new injectors are called for? Or should I look elsewhere?
Oliver
Chassis Model Number
Forums
SVO WVO Copper Coil 1/4 inch Connecting Swedge Fittings (x2)
1975 300D Smoother Transmission after valve adjustment
I successfully adjusted the valves on my 1975 300D using the kit from MercedesSource (awesome wrenches by the way). Only 2 exhaust and 1 intake needed to be adjusted but engine does run smoother. In addition, my transmission is shifting much smoother, almost too smooth, almost like it is slipping but not quite.
Should this be a concern I don't want to pre-maturely wear out my transmission.
Chassis Model Number
Forums
1985 300SD While in D will not go into N, R, or P somtimes
Over 200,000 miles, transmission never overhauled. I can always go from Park to Reverse and then to Drive. But sometimes while in Drive with my foot on the brake, I cannot get the shifter to go into Neutral to get to Reverse or Park. I move the shifter around but to no avail. This situations happens infrequently.
Another observation, when the shifting appears to be working, when I put it in Reveres, the whole body feels like it drops. And when I put the car in Drive it feels like it raises up. Normal/not normal, I don't know?
Chassis Model Number
Forums
300SD Turbo rebuild
In the midst of the 100,000 mile rebuild kit, and can't get the center beraing loose on the turbo. How in the h e double hockey sticks does that thing shake loose? Everything else has gone without a hitch so far. I'm deathly afraid of busting something banging on it. Help?
Thanks!
ps turbo is off the car due to the head gasket R&R. Figured since I had it open might as well rebuild the turbo and the starter...
Ben near Detroit
Chassis Model Number
Forums
1989 560SEC, Rear vibration over 60mph.
In hopes of not throwing expensive parts at a problem, over 60mph the rear end of my car starts to vibrate.
I have verified that the rear stabilizer link set needs to be replaced. Could the vibration in rear over 60mph be the bad stabilizer link set?
Also, the boot closest to the differential is torn on the axle assembly (driver’s side) and needs to be replaced. What do you think that means? Could the torn boot be a clue that the axle assembly is out? What would a bad driver's side axle assembly feel like at 55mph?
Chassis Model Number
Forums
84 300D hazard lights inoperable
Hello, The hazard lights in my benz failed suddenly, the hazard switch in the center console has power and is lit when driving lights are turned on, when the switch is depressed the light goes out and they do not flash, all other signal lights work fine, any thoughts?