$109.50
616 617 Diesel Water Pump Installation Kit w/ Limited Instructions
For 123 300D 300CD 300TD and 116 / 126 300SD 1977 to 1985. Fits SOME 240Ds see notes below
W116, BENZ AID - COMMON QUESTIONS AND ANSWERS
1982 300D Mild engine shake and smoke exhaust at initial startup
I am having a 'rough idle' issue I cannot seem to resolve; I will categorize as mild because I have worked on a two 240D (1980, 1981) and I was able to perform the recommended maintenance to have them idle very smoothly.
Additionally, hard initial start or it quits right after initial startup, then I am getting a blue smoke from the exhaust at the initial startup and for about 10 minutes before complete warmup.
Here is what I have done up to this point using the manuals, advice, and parts from mercedessource:
Chassis Model Number
Forums
1984 model 123 rear window molding
How is this removed? Special tool(s) required? I need to do some rust repair and it looks as if I can leave the rear window in place and just R and R the molding. Probably will have to buy new molding??
There isn't a glass shop here in Baja (Tijuana area) that I trust and I sure cannot afford to take it to the states.
Jim
Chassis Model Number
Forums
1983 300D Turbo Hood Hinge
My driver’s side hood at the hinge is slightly elevated above the fender. Is there an adjustment for this or is it fixed and thus requiring a hinge replacement? Thanks, Bill
Chassis Model Number
Forums
240D Blower fan
1974 240D - How do you access the blower fan for the heating system and is there a switch to change between heat and AC?
Thank You!
Chassis Model Number
Forums
87 300SDL run without alternator?
recently bought an 87'sdl around 2am lost the alternator 65mi from home does a mercedes have any way to get fuel without electric(like the bosch ve IP)
Chassis Model Number
Forums
'80 Wagon self leveling suspension question
Greetings,
I can hear some clunking with riding over bumps in the road. I read
Kent's SLS troubleshooting guide for some tips. All of the following
checked out: no leaks, fluid level good, pump working, sway bar links tight,
pulled an accumulator and seal good.
What isn't working is the manual operation of the leveling valve. I can
also see some cracks in the differential mount. The valve was replaced
1-2 yrs ago. I have a new mount, but stopped upon finding the valve was not
responding to manual operation. Any ideas/suggestion?
Chassis Model Number
Forums
80% Defrost only from blower
I have a 1981 300SD. Fixed my A/C. Now all my A/C blows out the defroster. I noticed all modes are 80% out the defrost ducts. Where do I go next? Vacuum? Electrical? Any diagrams available for either?
I do show 15" vacuum at the source. Low I know... seems to be the shift diaphragm on the pump. It also takes about 10 seconds to shut down after key off.
What's next?
thanks,
Bob
Chassis Model Number
Forums
Rough idle after warm up 1985 300D
I bought this car Nov 2004 and it had a rough idle when warmed up. In an effort to solve this I set the valves, replaced the injectors with rebuilt ones. No help. Meanwhile, and for other reasons, I installed a rebuilt engine Jul 2006. By Sep 2006 it too was idling rough after warm up.
Once again I verified valve settings and replaced the injectors with rebuilt units. I also replaced and adjusted the damper bolt, replaced the the motor mounts, transmission mounts and the engine shocks. No help.
In Jun 2007 I went all out and put in a dealer supplied rebuilt injection pump. No help.
Chassis Model Number
Forums
$147.00
Late 107 116 Chassis Turn Signal Switch Assembly
Order only by Vin # as explained below