Seat Belts in a 300D
I have 1992 300D and was wanting to take out the seatbelts to clean them . Does anyone know how to do this?
W116, Body and Interior Specific Aid
Wagon rear hydraulic suspenson
i have a 230te estste 1991 the problem is that i keep getting engine oil in the hydrolic suspension tank i know this as i have drained it off back down to empty after doing this within a week the oil light is back on on the dash and the suspension tank is full i cant see how it is happening would like to know how the oil can get into the tank .refrence it being lumpy it just feels like there is too much air in the tyres have set them to the correct pressure and that dosnt make any difference even tried a little less but no difference is that better info for you ps it rear hydrolic suspension
Forums
Taxonomy upgrade extras
Chassis Model Number
$22.50
115 116 123 and 126 Diesel Motor Mount Installation Help Kit
Instructions and special ratcheting hex tool and small combination wrench included 220D 240D 300D 300CD 300TD 300SDL
Small vacuum lines
I recently purchased a 79 300TD wagon. I have discovered many hidden problems with the car since I purchased the vehicle. The main one is the discovery of a 3" hole behind the battery and tray. It was hidden by a poor fiberglass patch job and the battery.This has been leaking into the car and sitting on the rear passenger floor boards. The floorboards are also rotting and hidden by rubber undercoat. Anyhow, when I bought the car I knew it needed a new heater servo and amplifier.
Forums
Taxonomy upgrade extras
Chassis Model Number
560SL squeeling noise
I have a 1986 sl. When I start quickly from a stop, I get a loud squeeling noise coming from underneath the car. If I start out slowly I don't hear it. I also get it when I accerlerate to pass someone. I thought it was a fanbelt problem, but it isn't. It's been going on for years and does not affect the performance of the car
Chassis Model Number
Forums
Diesel engine mount replacement
Hello fellow enthusiasts!I am working on a 83 300 TD. Any one have expierience replacing engine mounts? Passenger side looks tight and driver side looks even tighter. I tried loosening the passenger side 8mm allen head but it is siezed. Getting to the 6mm allen head bolts on top of the mount looks to be a challenge. Any suggestions.........John
Chassis Model Number
Forums
Suspension problem on '83 240D
So the other day I was out driving and started hearing a loud clicking noise whenever my '83 240D was in gear. I assumed it was the brakes since the rear brakes need to be done, but when I got out of the car and took a look I noticed that the rear right wheel was angled away from the body of the car. I jacked the right side up to get a better look at the suspension, but I know more about engines than I do suspensions and I really was just looking for something obvious that was broken.
Chassis Model Number
Forums
Loud reverberating whining noise coming from dashboard
Roughly 5-10 minutes after start (seemingly on colder days) my 1978 300D emits a loud reverberating whine that seems to come from the driver's side of the dash. While intermittent, it is quite unsettling. The best description I can give for the sound is that it is similar to the sound one might hear from a poorly lubricated fan (where the grease in the motor is caked with grime). The sound happens without either climate control or defrost on. Is it A/C related or something more serious? I know the vacuum system is in that general vicinity, but what else might be causing the problem?
Forums
Taxonomy upgrade extras
Chassis Model Number
$18.75
116 123 126 Diesel Steering Lock Vacuum Valve to Shut Off Engine
Diesel engine Shut-off Switch at Ignition Key - Get a spare while still available. This SHOULD BE REPLACED if you find oil inside the switch when changing the steering lock. .
$19.80
SMOOTH Antenna Mast Cable for Hirschmann Power Antenna W116 W123 W126
Includes written instructions by Kent Bergsma. Have questions? Watch the video below: