Kent's Factory Service Manuals collection is going on sale now. CLICK HERE.
Use this special swedge fittings when making any type of copper coil coolant heater for our SVO WVO fuel system. One end of this fitting clamps down tight on the copper pipe and the other end can accept any standard fitting with 1/4 inch male national pipe thread.
Very nice part. Only few very very minor scratches from having sat on shelf for so long. If you have a 140 you might want to pick this one up for a spare. These are very expensive from the dealer.
If your window washer pump is running and the squirter nozzles are not working properly, you may need replace them with new VDO / Siemens parts. There is nothing like seeing where you are going! Sold individually.
This is one of Kent's favorite tools. Lets you reach into tight places - very long nose curved pliers with teeth - like hemostat. With the locking handles it is amazing what this clamp / pliers can hold - and the tight places it can get into!
Correct metric hex bolt to mount the front crank pulley to the crank counterbalance. These bolts become rusty, are easy to round out, and sometimes even break duty to engine vibration. Check the torque of these bolts.
New Plastic Drain Plug. Fits all models listed below:
Mercedes-Benz 240D
Mercedes-Benz 280CE
Mercedes-Benz 280E
Mercedes-Benz 300CD
Mercedes-Benz 300D
Mercedes-Benz 300SD
Mercedes-Benz 300SDL
Mercedes-Benz 300TD
January 2019 notice: This filter is now available only in very limited quantities and may not be readily available in the future. This is why we are not able to include it in our full fluid flush kit ( See related products below) This is an often neglected filter.
WARNING: IF YOU ORDER THE WRONG ONE IT IS NOT RETURNABLE.
Set of 2 rubber motor mounts. These mounts fit TURBO DIESEL 300CD, 300D, 300SD, 300SDL, 300TD, and gas V8 380SE, 380SEC, 380SEL, 420SEL, 500SEC, 500SEL, 560SEC, 560SEL. These are high failure rubber parts on older cars.
Bad rear mount can cause excessive engine vibration. No instructions included at this time.
Fits 190D, 190E, 260E, 300CE, 300D, 300E, 300SDL, 300SL, 300TD, 300TE, 350SD, 350SDL, 500SL, E300, E320, SL320, SL500
Brand new Hazard Flasher rocker type switch, located in Center console between window switches for 240D 300D 300TD 190E 190D 300SD 420SEL 380SL and other models from 1982 to 1991. If you are unsure it will fit your model, visually verify picture with existing switch.
I like the convenience of using the factory jack points (holes) but I absolutely DO NOT like using the factory jack - except in cases of emergency road side repair. You all know it can be a little unstable... I solved this problem by using a large heavy duty bolt.
SPECIAL ORDER PART -- MAY BE UP TO A WEEK BEFORE SHIPPING!
We are the only company in the world that will offer you a master cylinder with a bench bleeding kit and full 30-minute video instructions on how you can do this yourself!
This kit will work on the following models:
This is a very important maintenance item for 126 300SD 5 cylinder turbo diesel owners. When these belts get loose or worn they can cause all kinds of problems like poor battery charging, engine overheating, jerky power steering, and noises that range from squeaking to rattling.
We are proud to offer the most complete and D.I.Y. doable high performance 617 turbo repair kit available on the market today. For optimal turbo performance, this is a service that should be performed every 100,000 miles (watch my video for explanation).
Good used headlight plugs. Excellent contacts but main wire has been cut and will need splicing with butt connectors.
Excellent used Left shoulder harness catch with wiring removed from low mileage car. If you have a 300SD you should get a spare.
Fits all W123 240D 300D 300CD 300TD 280E 280CE 1977 to 1985 Used Above average condition. good shafts and good joints for smooth movement of your windshield wiper arms - NO plastic wiper boots included and no mounting hardware ( use from your existing W123).
Good used ash tray. Needs cleaning. Excellent zebra wood with no cracks.
PLEASE READ CAREFULLY BEFORE ORDERING. Good used center dash wood strip. No Cracks with good finish. Slight bow in wood. THEY ALL ARE WARPED SOME DUE TO AGE!!! Missing metal backing.
NOTE: these bulb holders are the round style. They have 2 prongs for single element bulb when used with EUROPEAN headlights. You will need these when converting to Euro Headlights. Make certain your current socket is the same.
Bulb socket round style. Has 3 prongs for US headlights. Make certain your current socket is also round. Good condition, no corrosion.
Here is an assortment of 12 aluminum and copper sealing rings used in different locations on diesel engines and transmissions. This is not a complete set. Random spares from Kents stock. Handy to have in the garage for spares.
Crushable seal ring that fits between the prechamber and the cylinder head. Standard thickness approximately 2.0mm. SOLD INDIVIDUALLY. New seals may be required to repair fuel and air leaks around the top of the prechambers. Special tools are required to replace this seal.
Crushable seal ring that fits between the prechamber and the cylinder head. Genuine first oversize thickness 2.3mm. SOLD INDIVIDUALLY. New seals may be required to repair fuel and air leaks around the top of the prechambers. Special tools are required to replace this seal.
Plastic adjusting knob with clip. Fits many years and models with manually adusting mirrors.
Good used set of reading lights with no corrosion. No breaks in plastic. CAN NOT GUARANTEE THE BULBS
Good used flywheel stretch bolt as shown. Very limited stock. Torque converter flex plate bolts.
Excellent used rear check strap. Can also fit front doors but only has one stop possible as typical on the rears. Fits right or left. No cracks or bends. Complete as shown.
Very Good used wood piece. Hard to find in this condition. For models without sunroofs but can be modified for models with a sunroof by cutting out the trim hole. Wood superb. The finish is almost perfect except for two very small hairline cracks at the lower corners of the big cut-out.
Brand new balanced compressor wheel as shown. Increase horsepower by installing a new compressor impeller. The sharp clean edges really make a difference in compressor boost output. Most of these old wheels are worn. No instructions included.
UPDATE: This yellow slide hammer is no longer available. You can purchase our new silver Version 4 model. See related products below. This is one of the tools you will need to remove stubborn pre chambers.
Tightens and Removes Collar Nuts on 220D 240D 300D 300CD 300TD 300SD 300SDL 190D 2.2 1969 to 1987. Works on most Mercedes diesel engines up through 1987 only. ALSO FITS OM 636
New instrument cluster bulb with socket holder. Sold individually. PLEASE NOTE: This holder is only for the very small warning indicator bulbs, as well as your dash turn signal indicator lights. It is NOT for the larger bulbs that light your dash at night.
Good set of air conditioning compressor mounting bolts that mount the air compression to the engine. These are long special bolts. Sorry no spacers to washers.
Good used water pump double belt drive pulley for OM 617 turbo engines. WARNING: There are different sized pulleys floating around out there. Your engine could have been changed. PLEASE Measure your EXISTING pulley BEFORE ordering.
Getting to and removing the two hex head bolts that hold the starter to the bellhousing can be a real test of your sanity - especially if you don't have the right tool! You will need a heavy duty hex socket on a strong wobble extension.
All 5 cylinder turbo diesels 1978 - 1985 300D 300CD 300TD 300SD.
Good used air conditioning adjuster.
ONLY ONE LEFT. Good used activation rod and plastic clip as shown. Controls travel of vacuum control valve on the top rear of the injection pump. A plastic clip can easily break. May be some slight wear on the end of the metal rod but still usable.
Excellent used black plastic arm rest trim ring. has no breaks
Fits all 123 240D 300D 300CD 300TD 280E 280CE 1977 to 1985. This is a good used rear bumper rubber. There are no gouges or tears, only some slight scratches in places. The rubber trim piece that goes over the bumper shock mounts is in very good used condition.
Fits 450SL 450SLC 450SE/L 380SL 380SE/L 380SEC 500SEL 500SEC 420SEL 560SL 560SEL 560SEC 1973 to 1991 - ALSO FITS 126 Chassis 300SDL 350SDL.
Brand new complete wheel bearing kit. Includes all parts shown for right or left wheel. You with need to order 2 if you want a complete set of wheel bearings for both sides.
DESCRIPTION: Excellent used combination turn signal, high beam and wiper switch assembly. Note no cruse control level included. Easy to install buy pulling wiring bundle right out through the steering column. There will be some wear on the handle.
Excellent used part. Lens has no cracks and no crazing. Good Bright Chrome . No Bulb holder, rubber seal or reflector.
This is a genuine Mercedes used part. These are much stronger than the aftermarket ones available. Genuine are no longer made. No damage to the slot or the threads. Only for models listed. Does not work on later aluminum diesel engines. Collar nut holds pre-chamber in cylinder head.