$22.75
Radiator and Heater Hose Pick Removal Tool SET
Use all all vehicles to "unstick" old rubber coolant hoses. These have the best angles!
W126, Factory Books and Manuals
$3.85
SUPER GLUE Removable Blue Thread Locker
High Quality Thread Locking Compound Affordable Size
$6.95
80 AMP Glow Relay Strip Fuse - 3 Pack
300D 300CD 300TD 300SD 300SDL 190D
$14.60
123 126 201 124 SLS Hydraulic Suspension Tank Supply Hose Upgrade
Kit to replace feed hose from tank to pump on 300TD 300TE 190E 16V 560SEL and 560 SEC
Will not power past 75 mph! Slight loss of power uphill.
Hello, I have a 1984 300sd with 230,000 miles. Did alot of work to it, thanks to Mercedes Source. Anyway, did valve adjustment, compression test
(pressure max out close to 400). Changed injector nozzles to Bosios. Engine does not knock and is a bit smoother and responsive.
Problem: pedal to the floor on highway and will not get past 75 mph?! Sometimes loss of power up hill.
Have not changed the fuel lines from the tank. Is this the possible culprit?
Thanks, RP.
Forums
Taxonomy upgrade extras
Chassis Model Number
adjusting valves in 85 300sd
I have a 1985 300sd and have been told that this year has self adjusting valves, is this correct or do i ned to adjust them myself, thanks mitch
Forums
Taxonomy upgrade extras
Chassis Model Number
84 300SD Battery Drain
Anyone know how to diagnose a battery drain in a 126- 1984 300SD? I just bought this car a few months back with a new battery. I guess I know why the guy who sold it to me put a new battery in right before he sold it......
The car starts when jumped. The battery is 3 months new. I tested it with a multimeter. After sitting for the night the battery is around 10. After its jumped the battery reads 13.5. The alternator is fine as far as I can tell. Never died on me while I was driving and the battery charges while the car is running.
Chassis Model Number
Forums
'84 300SD driver's seat
I'm wondering if there's anyone out there that has had a seat motor go bad? I have replaced the seat switch on my driver's side to no avail and am wondering where to go next. I can hear the switch make a noise when I move it so I am assuming that is in working order. I have both of Kent's manuals (Chassis Door Maintenance and Repair & Front Seat Repair and Restoration) and neither speak directly to my situation. However, they do a wonderful job in describing how to remove the front seat, which I'm slightly afraid that's where I'm going to have to go to next!