All new 2006 to 2013 V6 and V8 engine repair kits! CLICK HERE to view AlL.
I purchased a higher output alternator for my 300sdl however it doesn't have a voltage regulator in it. My stock alternator has an internal voltage regulator. What do i do? Can I install a external one? What specs do i need to know? Where can i get one? thanks
I wanted to replace the rear windhshield in my 1983 300SD with a better one which came out of a 1985 300SD. I purchased the new seal made by Meyle from Mercedessource. The auto glass place was not able to install it because the 1985 glass is about 1" longer than the old one out of the 1983. Both cars are W126 models. Is there a series of years which will fit one but not the other? Is it possible to buy a new glass at a reasonable price? If yes where?
Thank you
Dieter
OK I fixed my rear suspension with help from here
and I fixed my seat for my rear with the seat fixer from here.
Great instructions and as Kent says "try the seat before installing"
Trully a HUGE differance....
But (no joke intended)
I discovered that the carpet was soaking wet at the two fastening points
at the back of the seat.
We had some rain so I thought that was the issue.
Dried everything and reinstalled the seat
(make sure you put the plastic trim on 1st)
Drove around and guess what ?
It was wet again!!!
n/a
My engine cranks for 8 - 10+ seconds before s-l-o-o-w-l-y catching on. Then it sputters for several seconds until I give it some gas to clear it out. I got this car 2 weeks ago and the previous owner said, "do not touch the accelerator pedal until it starts." It seems like it's flooding. This happens when hot,or cold. He also said to change the plugs and it would run well.
Runs fine on highway but seems to eat lots of gas (14 mpg?). 211,680 miles on Od. Original paint and leather in very good condition.
