CHECK OUT our new parts and kits for 2007 to 2012 models CLICK HERE to view all.
After turning off the car and removing the key the radio remains on and the aux fuel boost pump wired to activate in the aux mode continues to pressurize the fuel system. Car has 232K and in the last 19 years of ownership I have not replaced the ignition switch.
Is my diagnosis accurate of a failed ignition switch in the acc. position?
Do the replacement axles, the can style, include the spacers between them and the differential? I asked a while ago about having on spline stlye and one can style, and you said it probably wasn't harming too much. Now I have the money and would like to replace both axles, but to make the wrong (which I didnt know at the time) stlyle axle fit, I had to remove the spacer. I'm dead in the water if I remove the rear end and find out the axle doesn't fit due to a missing spacer.
I'm replacing the engine in my 1981 240d sedan. I've found a decent engine but it has a level control pump. Is there anyway to bypass or remove? Thanks for the help.
Hi,
I purchased today an '82 300D Mercedes with 150k miles for $1500, but there are no maintenance records that came with the car.
The car is running fine, but because I have no history, I prefer to assume that none of the maintenance is up to date.
Beside the obvious fluid and filter changes, WHAT ELSE I NEED TO DO TO AVOID CATASTROPHIC ENGINE FAILURES?
Is it possible to get a list or point me to one if it is already answered?
Thanks, Mike
My 1985 300D always has been running on the cool side(barely hitting 80C)
Ordered a thermostat with a recent MB Source order and finally installed the other day while doing regular maintenance.Re-filled with MB coolant50/50 H20 and now it runs hot! (95-97C). What should I suspect first?
Thanks,
Michael
I am looking for the stainless/chrome fender/wheel well trim that was available for the early 80's wagon.
It may not be a rare item, but I have yet to find it.
Thanks in advance
sean
