W116

$88.00

617 5 Cylinder Diesel Engine Flywheel and Ring Gear ( Used )

Fits 1975 to 1985 300D 300TD 300CD and 300SD with automatic transmission

$45.80

Early Diesel Pre Chamber Removal Threaded Tool (up through 1987 models only)

A slide hammer is required. A collar nut tool is required. See the full explanation below

$18.95

617 Diesel Flywheel Flex Plate Hold Down Ring - USED

For OM 617 non turbo and turbo in 1977 to 1985 300D 300CD 300TD and 300SD

Engine

Exhaust and Intake Manifold Gasket Leaks on Older Diesel Engines

Alert for all Diesel Owners - Check for loose Intake / Exhaust Manifold Nuts.

After installing new motor mounts, transmission vibrating on cross piece

I installed all three new motor mounts on my 1979 300SD W116, the engine did not line up very well while putting in new front mounts, prying the engine was necessary. The rear mount was a snap, however, I had to pry the bell housing from the cross member to get it to avoid vibration while underway, going in reverse up hill was very loud. The engine/transmission is settling back on the cross member. Any ideas?

The chassis has about 340k miles on it and the engine was rebuilt about 85k miles ago by the previous owner. I can say that the rubber under the car is warn.