83 300cd performance loss?
n/a
300cd 83 My top speed has dropped to 85mph rpm 3600. It was 108mph 4500rpm
please advise. also can i buy new injectrors with monarch nozzles installed
CHECK OUT our new parts and kits for 2007 to 2012 models CLICK HERE to view all.
n/a
300cd 83 My top speed has dropped to 85mph rpm 3600. It was 108mph 4500rpm
please advise. also can i buy new injectrors with monarch nozzles installed
I recently had my shop replace the ignition switch. Now the heater does not go off after the key is removed. I can't recall if this was the how it worked before, but it doesn't seem right. Before I return to the shop, I'd like to confirm this. Also, what can they possibly have done to make this happen? My understanding is that the wiring just plugs into the back of the switch. There doesn't seem much room for error.
Is replacing the shocks on my 79 W123 300D a DIY job? If so, is there anything I need to pay particular attention to? Thanks
Are the Astoria Flexx cv boots useable in Mercedes ?
They claim that the rubber ( silicone ) is better than OEM.
Does anyone have experience with these?
Thanks
deebos
Hi,
I'm installing the glow plug override kit on my 85 300dt. Wondering a good source of keyed power for the switch is? I'm almost thinking it'd just be easier to use a direct battery lead to avoid hacking away my harnesses, but if you know of an easy one I'd sure use it!
Thanks
Roger
About 2 months ago my wife took the car to exercise class and when she came out to come home and started the car it backfired and would not re-start. I checked it out the following day and though it didn't backfire it would not run for more than 1/2 a second. I had the vehicle towed to my house and have periodically tried to start it with the same result. It will fire, run for about 1/2 a second than shut off. It will continue to do that until I depress the accelerator pedal then it won't start at all.
9 times out of 10 my car starts immediately no problem. 1 time out of 10 there is a click and then nothing. After several attempts I can get the car started and then everything is OK for a couple more days...
Here's the mystery. I had my shop check the solenoid (OK) and replace the ignition switch using the kit sold on this site. Everything was fine for a couple of days, then the same problem occurred. We can almost live with the problem but I'm concerned that one day we won't be able to start it at all.
Replaced turn signal stalk for my 1982 300sd I got from you. I now have no horn. I cannot figure out were the two brass rings make ground contact. Have I a missing contact plate or not connected the harnass properly?
Ps Thank you for your quick reply re fuel sender