1983 300D fuel injector brand mixing
Why is there the warning for the Monark diesel injectors that they not be mixed with Bosch injectors?
Thanks!
CHECK OUT our new parts and kits for 2007 to 2012 models CLICK HERE to view all.
Why is there the warning for the Monark diesel injectors that they not be mixed with Bosch injectors?
Thanks!
I own a 1977 300D. I was driving home one day and I noticed when I arrived to Traffic lights the car acted like it wanted to shut off. I resumed driving and as I was getting close to my home, the car shut off. Since then I have replaced the battery, replaced the starter all with no luck. On a fully charged battery the engine turns slow, and acts like it want to start but then dies. Upon a second attemtp at starting, the engine gives me a click, and the engine does not turn! I am super confused. can anyone help?
thank you in advance!
Hi all and thanks to Mercedessource for all the help getting "Old Yella" back to nearly original shape. My question concerns the heat in my old girl. I replaced the monovalve some time ago and it had the typical tear in the rubber portion of the valve. The replacement gave me heat, though intermitently. Now the heat will roast you but if I am on the road a while it will subside and eventually I will feel cool air coming out of the vents. Then the heat will come back and the cycle starts over again. Roast then cool.
Just completed a compression check on my high mileage 240d.
#1 120/200
#2 180/320
#3 190/340
#4 180/320
Number one is not looking so great. The test was completed with the engine cold. I did try adding oil and the change was marginal 130/220 on number one.
The engine runs smooth with little smoke at start up. What my next step? Pull the head and have a look at the valves?
Thanks for your imput.
The compression tester and booklet were excellent.
Hey everyone,
I cannot for the life of me find the turn signal relay on my 1979 300D. My left signal flashes twice as fast as the right one and the bulb in front is very weak while the rear one is bright. Both bulbs are brand new and all the connections look good. I also replaced the hazard button on the console and the problem remains.
I have the new turn signal relay from mercedessource but I can't find where it goes. It definitely doesn't go under the console like some of the posts I've read and it doesn't seem to be anywhere under the drivers side dash. I traced the wiring from the steering column to one relay but its a much larger 8 or 9 pin and that seems to be the only relay under there that the turn signal wiring goes through.
diy ball joint replacement - 1985 300td Sedan
Currently squeeks like an old couch! Just embracing the diy arena after the local mechanic quoted 3.1 hours labor for each joint (it it true???) Have ordered replacement ball joints. Any helpful hints or how to is appreciated - have searched the site. Your input is valuable - is this doable for the novice, novice, first timer?