Kent's Mercedes SL Roadster Collection for Sale! CLICK HERE to view all.
I am putting in my new balanced injectors and injection pump stub shaft o-rings. I took off the crossover pipe to gain access to the third injector and just give me more room to put hard lines back in after cleaning them off course. I found that there is an oily gunk in the cross over pipe and the intake should I be worried about my turbo? I do have a small oil leak from the turbo (the only oil leak on the car) are the doughnuts bad turbo getting bad ect. Should I take the intake off and clean it and get a new intake gasket soon?
n/a What color paint was used on the alloy rims on the 1983 300sd.
Drivers door lock will not turn either direction. Pulled door panel can see single wire to handle assembly broken. How do I get handle loose from latch assembly? Afraid to break the rod. What is the trick??Need to pull handle out from door to access and repair the wire.
Wow! Times like these I feel really alone in rural N.W. Indiana!! I went to change the radio (cassette) to a more modern am/fm/cd Blaupunkt Saturday night. Speaker wires were the hangup and I was told I need a floating ground adapter...? I thought each speaker had both wires coming to the radio and I could connect them as such to each corresponding lead from the new radio. The "experts" said I'd fry the radio and wanted to sell me this "floating ground adapter" for $40. I didn't buy it...I re-installed the former Becker original and had to re-splice the brown ground wire as I was all set to splice and connect ASAP.
The burl wood trim on the dash and doors of my "86 560 SEL needs help, but I have not found a source to help with repair or replacement except the dealer which runs over $3500. Any ides's? john
Had minor vacuum problems (power locks don't work) but lately, trans shifting is slow. When engine is warm and reversing from parking, I need to rev the engine a bit before it shifts into Drive. Also, it takes a little longer to shift from 3rd to 4th with motor revving a little higher and a little longer.
I went to Kent's "Diesel Vacuum Source Troubleshooting and Repair" booklet and here's what I found. The booklet suggests the vacuum to the Injection Pump Shut Off Valve be tested. My car does not have one of those!
Without warning, no glow plug light in the dash and glow plug relay under hood clicks on then off immediately. (Chicago) I use the block heater overnight so morning starts are a given, but after teaching all day, afternoon starts, it seems the glow plugs sort of work still if I wait 15 seconds, but startup idle is a bit rough and a little black smoke puffs out where before there was none. The engine was factory replaced before I got it and has about 40K miles on it. QUESTION: For emergency starting until I can get the replacement parts for repair, can I run a wire from the battery terminal to the # 1 glow plug top, hold it there for 10 seconds, and then go start the engine? (maybe 12 sec. if in lower teens outside temp).?? TIA in advance for your most valued advice to everyone.