84 300D shift problems
n/a Acceleration is extremely slow, shifts to 2nd at 4000 RPM top speed 45 MPH the problem came on suddenly .
W123
Body and Exterior Trim
Troublesome Trunk Seal Leaks
Be sure to look UNDER the trunk seal - you might be surprised!
Hooking up 5/16 hose to change mineral oil in SLS on 300td
Trying to hook up hose to change fluid in SLS system on my 82 wagon. I am missing something. Cannot get nut off of line that goes into canister. Just got my fluid and filter and was hoping to do it this weekend.
Chassis Model Number
Forums
85 300TD fuel sending unit removal
My fuel gauge does not work. It used to read about 1/4, but now doesn't read at all. I read a post here about cleaning the sending unit, but cannot find it. Is there a diagram available of the wiring for the unit? What do I have to remove to get to it on an 85 300TD with a rear seat?
Chassis Model Number
Forums
$99.00
617 Diesel Garrett T3 Turbocharger High Performance Basic Overhaul Kit
For all 5 cylinder Garrett turbos on 300SD 300D 300CD and 300TD 1978 to 1985
1983 300td Cruise not working at all.
Cruise control not working. No accceleration, nothing.
Chassis Model Number
Forums
300td Speedometer
I have just purchased a 300td. All is good except the speedometer makes a ticking/scraping noise until I reach speeds upto 60+. The needle doesn't move in a smooth motion but more like the second hand of a battery operated wall clock. Also the speedometer is off 10mph or so. Do I need to replace the cable or the whole unit?
Thanks.
Chassis Model Number
Forums
83 300CD 2-way Vacuum Check Valve?
83 MB 300 CDT
One drivers side vacuum check valve yellow three way. Vacuum source and two outlets.
The other check valve adjacent is yellow two way. Vacuum source and one outlet.
What is the yellow two way replacement?
Chassis Model Number
Forums
Engine
Checking for Slow Power Steering Fluid Leaks
Check Your Low Pressure Power Steering Pump Hose
83 300cd performance loss?
n/a
300cd 83 My top speed has dropped to 85mph rpm 3600. It was 108mph 4500rpm
please advise. also can i buy new injectrors with monarch nozzles installed